Petra KM42.17 — решение проблем с кофейными аппаратами: советы и рекомендации [23/24]

Petra KM42.17 Руководство по эксплуатации онлайн [23/24] 435100
23
sed against each other. However, if this occurs
anyway, it must be replaced.
No coffee emerges, although the pump is operating
Set the rocking lever (5) in area to the left as far
as possible.
It is possible that the center opening of the pad cas-
sette (6) is clogged by coffee powder or calcium
deposits. A relief valve reduces the pressure to a
harmless value and directs the water into the water
tank (4).
Routinely check that the center opening of the pad
cassette (6) is unobstructed.
Hot water cannot be removed
Check if the rocking lever (5) is at .
The water in the water tank cools off
If the appliance is started, although the rocking lever
(5) is not at or or if the center opening of the
pad cassette (6) is clogged by coffee powder or calci-
um deposits, a relief valve channels hot water into the
water tank (4).
Routinely check that the center opening of the pad
cassette (6) is unobstructed.
The rocking lever cannot be opened
If the center opening of the pad cassette (6) is clog-
ged by coffee powder or calcium deposits, the pres-
sure cannot be completely escape and the rocking
lever (5) is blocked.
Pull the power plug and leave the appliance for
several hours, so that the pressure can be redu-
ced. If this does not work, you can open the ope-
ning in the pad cassette (6) with a needle. Remo-
ve all removable parts and place the appliance on
its side. The opening in the pad cassette (6) is now
accessible from below. Try to open it with a needle.
Careful, it may spray coffee.
Routinely check that the center opening of the pad
cassette (6) is unobstructed.
The coffee quantity is reduced
Set the rocking lever (5) in area to the left as far
as possible.
It is possible that the center opening of the pad cas-
sette (6) is partially clogged by coffee powder or cal-
cium deposits.
Routinely check that the center opening of the pad
cassette (6) is unobstructed.
Calcium deposits clog the inner lines. This may
damage the appliance.
The appliance must be decalcified.
The outlet drips when reheating
If you set the rocking lever (5) after brewing or the
rinsing process at , a lengthier post-dripping will
be reliably prevented.
Calcium deposits inhibit the function of the valves.
The appliance must be decalcified.
The appliance switches off after heating
If the readiness to start is not achieved during heating,
the appliance will shut off after approx. 2 minutes.
The appliance may not be operated in locations
that are located higher than 1,500 m above sea
level. The water would otherwise boil prior to rea-
ching the brewing temperature.
Milk is not suctioned
If you have not frothed milk over an extended period,
it may be possible that the required steam will not be
available during the first attempt.
Wait until the start/stop button (12) is again illumi-
nated in green and try a second time.
If you have not frothed milk over an extended peri-
od, rinse the professional milk frothing unit (24) first
as described in section "rinse after use". This provi-
des a more consistent output during subsequent
frothing.
The steam nozzle (23) could be plugged by calcium
deposits or such.
Clean the steam nozzle (23) as described in sec-
tion "cleaning and service".
Milk froth does not develop
The air channel (29) on the tube adapter (26) is con-
taminated or damaged due to improper cleaning.
Clean the professional milk frothing unit.
Replace the damaged tube adapter (26).
Extreme splattering of the milk froth
The tube (25) is incorrectly assembled.
The uncut end must be placed on the tube adapter
(26).
The tube adapter (26) is not placed far enough in the
mixer (27).
Push the tube adapter (26) completely onto the
mixer (27) until the stop.

Содержание

Узнайте, как устранить распространенные проблемы с кофейными аппаратами, включая засоры и необходимость декальцинации. Подробные инструкции для эффективного использования.

Скачать