Unit UEK-276 Инструкция по эксплуатации онлайн [8/20] 441976

Electric kettle | UEK-276

ENGLISH

Filling

• Remove the kettle on the Power Base (6).

• Open the Lid (2) and ﬁll the kettle via the Lid (2) aperture.

• Watch the level of water on the Water Level Gauge (4). You must boil at least

two cups of water, but the water level must be below the «MAX» mark.

• Do not overﬁll the kettle. If the kettle is overﬁlled, there is a risk that boiling

water may be ejected.

• Close the Lid (2) and press it down. Check, that it is fully closed; otherwise, the

kettle may not switch off when it is boiling.

Switching on

• Check that the Switch (5) is in the «OFF» position (lift the kettle from the Pow-

er Base (6) and set it down again).

• Plug the Power Base (6) into the wall socket. If necessary, switch it in to the

socket. Gently put the kettle on Power Base (6), taking care not to spill any

water.

• Press the Switch (5) down. The Indicator Light (7) will light up, and the kettle

will start to heat.

Switching off

• When the water has boiled, the kettle will switch off automatically. The Switch

(5) will return to the «OFF» position and the Indicator Light (7) will blink off.

• If you need to switch the kettle off at any time before the water is boiling,

simply press the Switch (5) to «OFF» position. The Indicator Light (7) will blink

off.

Points to note

• When you lift the kettle from the Power Base (6), you may see moisture on the

surface of the Power Base (6). This is due to the fact that when the automatic

switch-off of the kettle is actuated, part of the steam inside it leaves through

the special holes in the body of the appliance. This is perfectly normal, and