Qtech QSW-8200-28T-AC — iPv6 Multicast Protocol User Manual: Configuration Guide [33/39]

Превью страниц Страница 33 / 39

User Manual

Chapter 2. IPv6 Multicast Protocol 33

www.qtech.ru

 port-channel: port aggregate

 Command Mode: Global Mode

 Default: When a port is made static and dynamic mrouter port at the same time, it’s

the static mrouter properties is preferred. Deleting the static mrouter port can only be

done with the “no” form of this command.

 Example: Switch(config)#ipv6 mld snooping vlan 2 mrouter-port interface

ethernet1/0/13

2.2.10 ipv6 mld snooping vlan mrouter-port learnpim6

 Command: ipv6 mld snooping vlan <vlan-id> mrouter-port learnpim6

 no ipv6 mld snooping vlan <vlan-id> mrouter-port learnpim6

 Function: Enable the function that the specified VLAN learns mrouter-port (according

to pimv6 packets), the no command will disable the function.

 Parameter: <vlan-id>: The specified VLAN ID, ranging from 1 to 4094.

 Command Mode: Global Mode

 Default: Enable

 Usage Guide: Enable the function that the specified VLAN learns mrouter-port

(according to pimv6 packets). After a port received pimv6 packets, it will be set to

mrouter port for implementing the automatic learning.

 Example: Disable the function that vlan 100 learns mrouter-port (according to pimv6

packets).

 Switch(config)#no ipv6 mld snooping vlan 100 mrouter-port learnpim6

2.2.11 ipv6 mld snooping vlan mrpt

 Command: ipv6 mld snooping vlan <vlan-id> mrpt <value>

 no ipv6 mld snooping vlan <vlan-id> mrpt

 Function: Configure the keep-alive time of the mrouter port.

 Parameter: vlan-id: VLAN ID, the valid range is <1-4094>

 value: mrouter port keep-alive time with a valid range of <1-65535> secs.

 Command Mode: Global Mode

 Default: 255s

 Usage Guide: This configuration is applicable on dynamic mrouter port, but not on

static mrouter port. To use this command, MLD snooping must be enabled on the

VLAN.

 Example: Switch(config)#ipv6 mld snooping vlan 2 mrpt 100

2.2.12 ipv6 mld snooping vlan query-interval

 Command: ipv6 mld snooping vlan <vlan-id> query-interval <value>

 no ipv6 mld snooping vlan <vlan-id> query-interval

 Function: Configure the query interval.

 Parameter: vlan-id: VLAN ID, the valid range is <1-4094>