Qtech QSW-8200-28T-AC-DC Команды для протокола многоадресной рассылки онлайн [6/39] 481627

User Manual

Chapter 1. IPv4 Multicast Protocol 6

www.qtech.ru

1.1.2 access-list (Multicast Source Control)

 Command: access-list <5000-5099> {deny|permit} ip {{<source> <source-

wildcard>}|{host <source-host-ip>}|any-source} {{<destination> <destination-

wildcard>}|{host-destination <destination-host-ip>}|any-destination}

o no access-list <5000-5099> {deny|permit} ip {{<source> <source-

wildcard>}|{host <source-host-ip>}|any} {{<destination> <destination-

wildcard>}|{host-destination <destination-host-ip>}|any-destination}

 Function: Configure source control multicast access-list; the “no access-list <5000-

5099> {deny|permit} ip {{<source> <source-wildcard>}|{host <source-host-ip>}|any-

source} {{<destination> <destination-wildcard>}|{host-destination <destination-host-

ip>}|any-destination}” command deletes the access-list.

 Parameter: <5000-5099>: source control access-list number.

 {deny|permit}: deny or permit.

 <source>: multicast source address..

 <source-wildcard>: multicast source address wildcard character.

 <source-host-ip>: multicast source host address.

 <destination>: multicast destination address.

 <destination-wildcard>: multicast destination address wildcard

character.

 <destination-host-ip>: multicast destination host address.

 Default: None

 Command Mode: Global Mode

 Usage Guide: ACL of Multicast source control list item is controlled by specifical ACL

number from 5000 to 5099, the command applies to configure this ACL. ACL of

Multicast source control only needs to configure source IP address and destination IP

address controlled (group IP address), the configuration mode is basically the same to

other ACLs, and use wildcard character to configure address range, and also specify a

host address or all address. Remarkable, “all address” is 224.0.0.0/4 according to group

IP address, not 0.0.0.0/0 in other access-list.

 Example: Switch(config)#access-list 5000 permit ip 10.1.1.0 0.0.0.255 232.0.0.0

0.0.0.255

1.1.3 ip multicast destination-control

 This command is not supported by the switch.

1.1.4 ip multicast destination-control access-group

 Command: ip multicast destination-control access-group <6000-7999>

 no ip multicast destination-control access-group <6000-7999>

 Function: Configure multicast destination-control access-list used on interface, the “no

ip multicast destination-control access-group <6000-7999>” command deletes the

configuration.

 Parameter: <6000-7999>: destination-control access-list number.