Qtech QSW-8200-28T-AC-DC Команды для протокола многоадресной рассылки онлайн [9/39] 481627

User Manual

Chapter 1. IPv4 Multicast Protocol 9

www.qtech.ru

configuring the command, multicast data received from every interface does not have

matching multicast source control list item, and then they will be thrown away by

switches, namely only multicast data matching to PERMIT can be received and

forwarded.

 Example: Switch(config)#ip multicast source-control

1.1.9 ip multicast source-control access-group

 Command: ip multicast source-control access-group <5000-5099>

 no ip multicast source-control access-group <5000-5099>

 Function: Configure multicast source control access-list used on interface, the “no ip

multicast source-control access-group <5000-5099>” command deletes the

configuration.

 Parameter: <5000-5099>: Source control access-list number.

 Default: None

 Command Mode: Interface Configuration Mode

 Usage Guide: The command configures with only enabling global multicast source

control. After that, it will match multicast data message imported from the interface

according to configured access-list, such as matching: permit, the message will be

received and forwarded; otherwise the message will be thrown away.

 Example:

 Switch (config)#interface ethernet1/0/4

 Switch (Config-If-Ethernet1/0/4)#ip multicast source-control access-group 5000

 Switch (Config-If-Ethernet1/0/4)#

 Switch(router-msdp)#default-rpf-peer 10.0.0.1 rp-policy 10

1.1.10 multicast destination-control

 Command: multicast destination-control

 no multicast destination-control

 Function: Configure to globally enable IPv4 and IPv6 multicast destination control,

after configuring this command, IPv4 and IPv6 multicast destination control will take

effect at the same time. The no operation of this command is to recover and disable the

IPv4 and IPv6 multicast destination control globally.

 Parameters: None.

 Default: Disabled.

 Command Mode: Global Configuration Mode.

 Usage Guide: Only after globally enabling the multicast destination control, the other

destination control configuration can take effect; the destination access list can be

applied to ports, VLAN-MAC and SIP. After configuring this command, IGMP-SNOOPING

and IGMP will match according to the rules mentioned above when they try to add

ports after receiving IGMP-REPORT.

 Example:

 switch(config)# multicast destination-control