Qtech QSW-8200-28T-AC-DC Команды интерфейса уровня 3 онлайн [19/47] 481627

User Manual

Chapter 1. Commands for Layer 3 Forwarding 19

www.qtech.ru

1.2.31 ipv6 nd other-config-flag

 Command: ipv6 nd other-config-flag

 Function: Set the flag representing whether information other than the address

information will be obtained via DHCPv6.

 Parameters: None.

 Command Mode: Interface Configuration Mode.

 Default: Information other than the address information won’t be obtained via

DHCPv6.

 Examples: Set IPv6 information other than the address information in interface vlan 1

will be obtained via DHCPv6.

 Switch(Config-if-Vlan1)#ipv6 nd other-config-flag

1.2.32 ipv6 nd managed-config-flag

 Command: ipv6 nd managed-config-flag

 Function: Set the flag representing whether the address information will be obtained

via DHCPv6.

 Parameters: None.

 Command Mode: Interface Configuration Mode.

 Default: The address information won’t be obtained via DHCPv6.

 Examples: Set IPv6 address information in interface vlan 1 will be obtained via DHCPv6.

 Switch(Config-if-Vlan1)#ipv6 nd managed-config-flag

1.2.33 ipv6 neighbor

 Command: ipv6 neighbor <ipv6-address> <hardware-address> interface <interface-

type interface-name>

 no ipv6 neighbor <ipv6-address>

 Function: Set static neighbor table entry.

 Parameters: Parameter ipv6-address is static neighbor IPv6 address, same to interface

prefix parameter, parameter hardware-address is static neighbor hardware address,

interface-type is Ethernet type, interface-name is Layer 2 interface name.

 Command Mode: Interface Configuration Mode

 Default Situation: There is not static neighbor table entry.

 Usage Guide: IPv6 address and multicast address for specific purpose and local address

can not be set as neighbor.

 Example: Set static neighbor 2001:1:2::4 on port E1/0/1, and the hardware MAC

address is 00-03-0f-89-44-bc.

 Switch(Config-if-Vlan1)#ipv6 neighbor 2001:1:2::4 00-03-0f-89-44-bc interface Ethernet

1/0/1

1.2.34 interface tunnel

 This command is not supported by this switch.