Timberk T-S28 (T-AC07-S28-X) Инструкция по эксплуатации онлайн [10/50] 501876

IM2019

Fig. 3

Wall-through hole

1. Make a hole with an electric hammer or a water drill at the predetermined position on the wall

for piping, which shall slant outwardly by 5°-10°.

2. To protect the piping and the cables from being damaged running through the wall, and from

the rodents that may inhabit in the hollow wall, a pipe protecting ring shall be installed and

sealed with putty.

Note: Usually, the wall hole is Φ60mm~Φ80mm. Avoid pre-buried power wire and hard wall

when making the hole

Fig. 4

Route of Pipeline

1. Depending on the position of the unit, the piping may be routed sideway from the left or the

right (Fig. 5), or horizontally from the back (Fig. 6) (depending on the pipe length of the indoor

unit). In the case of sideway routing, cut off the outlet cutting stock of the opposite side.

2. The power cable may be routed separately from the piping. Cut off the outlet cutting stock and

then run the power cable through the hole.