Timberk T-PAC07-P09E Инструкция по эксплуатации онлайн [12/33] 501882

IM2019

SLEEP mode

This mode can be enabled using the «SLEEP» and « » buttons

Note: It is impossible to turn on the SLEEP mode in the dehumidifying or fan modes.

COOL mode

Press «MODE» until the «COOL» indicator lights up. Click buttons « » or « » to select the

needed room temperature. The temperature can be set in the range 16 °C−31 °C. Press the

«SPEED» button to select the fan speed.

DRY mode

Press «MODE» until the «DRY» indicator lights up. In this mode, you can’t select or adjust the

fan speed temperature. Close windows and doors to achieve the best drying effect. Do not put

the duct to window.

FAN mode

Press «MODE» until the «FAN» indicator lights up. Press the «SPEED» button to select the fan

speed. You can’t adjust the temperature. Do not put the duct to window.

10. MAINTENANCE

ATTENTION!

Disconnect the unit from the mains before cleaning.

1. When cleaning the air conditioner, do not use gasoline, solvents and other chemically active

substances.

2. To avoid electric shock and damage to electrical components, do not pour water on the air

conditioner from a tap or a hose.

3. Do not use the air conditioner if the power cord is damaged. On the subject of replacing a

damaged power cord, contact an authorized service center.

Air filter

Clogging with dust particles impairs the air conditioner operation efficiency, therefore clean the

filter no less than once in two weeks.

Filter removal/installation

On the back of the housing, slide the plastic lock, unscrew the four screws and pull out the filter

frame (as shown in the figure below)