Grillo PK 400 Инструкция по эксплуатации онлайн [11/42] 520778

Grillo PK 400 Инструкция по эксплуатации онлайн [11/42] 520778
PK400/ Istruzioni originali – Original Instructions – Instructions originales – Original-Anleitungen – Instrucciones originales
GEARBOX OIL
Change the oil every 1000 hours using SAE 80 W 90 gearbox oil. Quantity: 2,5 kilos. The cap is under the
front gearbox casing (Fig. 14 ref. C). The cap to pour in the oil is on the central gearbox casing (fig. 14, ref.
B). It is possible to adjust the cables by means of two adjustment nuts (ref. Fig. 17)
REAR AXLE OIL
Change the oil every 1000 hours using SAE 80 W 90 gearbox oil. Quantity: 1,6 kilos.
The cap is under the central casing (Fig. 18 ref. B). The cap to pour in the oil is on the central casing (fig. 16,
ref. A).
BRAKE FLUID
Check the brake fluid level in the reservoir on the dashboard every 8 hours (fig. 2 ref. 9). If necessary add
DOT.4 (SAE J 1703) brake fluid. Check the braking system periodically for leaks. If it is necessary to bleed,
proceed as follows: if you have the special tool, connect it in the place of the tank cap; bleed the rear trailer
circuit first, then the front circuit.
Users without the tool can try to bleed the circuits using the machine's pump, but this operation is not always
successful. The bleed screw is on the brake tongs (fig. 19 ref. A).
NOTE Clean the tank cap (fig. 2 ref. 11) and the surrounding surface thoroughly. Pay attention when opening
the cap in order to avoid possible impurities entering the tank. For filling up always use a funnel with an
integrated filter with a 0,12 mm or smaller mesh.
WARNING The brake fluid absorbs humidity, therefore, if the vehicle is mainly used in areas with a high
percentage of humidity, the liquid has to be changed once a year.
CAUTION! The brake fluid is poisonous and highly corrosive. In case of accidental contact, immediately
wash the affected parts with water and neutral soap, then rinse well.
BRAKE ADJUSTMENT
The disk brakes of the service brake are self-adjusting.
The parking brake can be adjusted operating on the register located on the cable (Fig. 4A)
IMPORTANT!
Grease the universal joint, the steering joints periodically (fig. 24) and the adjustment greaser (fig. 25).
AIR FILTER
The air filter is placed under the body (fig. 15). In dusty areas, daily cleaning is recommended.
RUBBER TUBINGS
For the maintenance of the rubber flexible tubings of the brake and feed system, follow the instructions in this
chapter accurately. Ozone, high temperatures and long lack of liquid in the system can cause the tubings to
harden and break, leading to possible liquid leaks. Attention is therefore necessary.
ELECTRICAL SYSTEM (FUSE BOX)
The electrical system is protected by fuses, which once interrupted, cause the total inefficiency of the whole
electrical system. They are placed in front of the passenger's seat (fig. 26).
Once the failure has been sorted out you need to replace the fuse with one having the same capacity. Never
replace with a fuse having another capacity. If the inconveniences should continue after having done the above
mentioned actions, contact an authorised Grillo Dealer.
OIL FILTER BULB
This component engages the oil warning light as soon as oil is missing. (fig. 21)
LOAD BED LIFTING ELECTROVALVE
In fig. 22 you can see the electrovalve that manages the load bed's tipping.
PRIORITY VALVE
In fig. 23 you can see the priority valve that divides the oil flux between the power steering to the piston engine
exhaust electrovalve.

Содержание

Скачать