AXIOMET AX-T01 Расширенная инструкция онлайн [4/4] 528196

• Circuit breakers

• Fuses

• Wires and cables

Note: The voltage detector can be used to find a break in a wire:

• To find a break in a hot conductor, trace the wire until the signal stops.

• To find a break in a neutral conductor, connect a load between the hot and neutral.

Trace the wire until the signal stops.

1. Test the unit on known functioning circuit or component.

• If the unit does not function as expected on a known functioning circuit, replace the batteries.

• If the unit still does not function as expected, send the unit to repair.

2. Place the probe tip on or near the circuit or unit to be tested.

LED and audible beeper indicate the presence of AC Voltage from 200~1000 VAC (50/60Hz).

Note: The voltage detector cannot detect voltage on armored cable or on cable in conduit,

behind panels, or in metallic enclosures.

Specifications

Indicators: LED and audible beeper

Voltage Range: 200~1000 VAC (50/60Hz)

Over voltage Category: Category III - 1000V

Pollution Degree: 2

Battery: Two 1.5 volt batteries (AAA, NEDA 24A or IEC LR 03)

Battery Replacement

1. Disconnect the unit from the circuit.

2. Remove the battery compartment cove.

3. Replace the batteries (observe polarity).