Ardesto IH-2000-Q1S Инструкция по эксплуатации онлайн [21/28] 548663

26. NEVER place hands under the heating elements. ALWAYS allow heating

element to cool at least 10 minutes before touching the heating tube or adjacent

parts

27. Observe that all applicable local and national electrical codes are met and a

safe electrical ground system is installed before attempting to operated the heater.

Refer to the proper installation procedures

28. This product contains recyclable materials. Do not dispose this product as

unsorted municipal waste. Please contact your local municipality for the nearest

collection point.

29. Obey the same re safety rules you observe when you work with hot plate,

high intensity infrared heaters, propane or acetylene torches, soldering irons, and

other equipment that gets very hot.

30. Know where the nearest re extinguisher is located and how to use it.

36.

Know how to put out re from all types of material near the infrared heater.

37.

Statement: heater is not located immediately below a socket-outlet.

38.

Children of less than 3 years should be kept away unless continuously

supervised.

39.

Children aged from 3 years and less than 8 years shall only switch on/

o the appliance provided that it has been placed or installed in its intended

normal operating position and they have been given supervision or instruction

concerning use of the appliance in a safe way and understand the hazards

involved. Children aged from 3 years and less than 8 years shall not plug in,

regulate and clean the appliance or perform user maintenance.

40.

Some parts of this product can become very hot and cause burns. Particular

attention has to be given where children and vulnerable people are present.

ASSEMBLY INSTRUCTIONS

Wall mounted

1. Make holes on wall where heater is to be mounted with a pencil. Use a level to

make sure heater will be mounted straight.

2. Drill holes with a smaller diameter drill bit than the plastic anchor.

3. Insert the point end of the plastic anchor into the wall. Tap the anchor with a

hammer until the anchor is ush with the wall.

4. Using a screwdriver attach the mounting bracket to wall using screws

provided