Ardesto IH-2500-CBN2B Инструкция по эксплуатации онлайн [27/32] 548664

• The supplied mains cable must not contact the top surface of the heater during

operation.

• Heater must not be located immediately below a socket outlet. Electrical con-

nections must be made outside of the footprint of the unit to avoid heat build-

up. If the heater is to be mounted on an incline (e.g. sloping roof), ensure the

electrical connection is located below the lowest end of the heater.

• Joists, beams and rafters shall not be cut or notched to install the appliance.

• This heater is not intended for ceiling-recessed installation. Do not install point-

ing directly downwards.

• The identication mark and model reference should be visible after installation.

• The heater must not be attached facing or close to any combustible material (eg,

wood or PVC cladding, fascia or sot) or other materials that could blow onto

the heater.

• The xed wiring insulation coming into contact with parts with a temperature

rise of greater than 50°C must be protected, for example, by sleeving having an

appropriate temperature rating.

• Exercise caution when siting the heater stand that the heater cannot accidental-

ly be touched, knocked-over or that the wire causes a tripping hazard.

• Never place the stand and heater next to a swimming pool, pond or other water

source.

INITIAL USE:

The unit may emit odour or vapour on initial use or if heater has not been used for

an extended period. This is normal