Chieftec CEB-7035S Руководство онлайн [2/4] 549115

Note

Connect the USB 3.0 cable to the PC, the HDD will be recognize.

If you need to replace the hard disk, close all windows, remove devices safely and the

HDD to stop running. Then follow the instructions from step 1. to 6. to remove and replace

the HDD.

When connecting the enclosure for the first time, please wait until it is recognized

(different OS and different hardware may cause delay).

The enclosure is also compliant to USB 2.0 interface, reaching a transfer rate of maxi-

mum 480Mbps.

If the desktop or laptop does not support USB 3.0 interface, please use the external

PCI Express card (for desktop), or PCMCIA Express card (for laptop) to upgrade the

system to the best USB 3.0 transfer rate available.

Please ensure that the USB 3.0 host card driver supports the operating system.

Before connecting to the PC, please ensure that the HDD is installed correctly.

Please partition and format the new HDD before use.

To avoid any loss of data, do not remove the enclosure while the HDD is in use.

Under Windows XP OS, the maximum capacity of the HDD is 2TB (Please check

Windows official website for detailed information).

If the HDD is not in use, please leave it disconnected.

This product is for use in dry, indoor locations only. Avoid exposure to wet or moist

conditions, only take hold of it with dry hands.

10.

Slide hard drive into SATA connector and tighten

the screws

Push the drive caddy back into the enclosure.

Connect the LED signal cable to the PCBA.

Make sure to fasten the 2 screws on the back of

the enclosure.