Kaiser S6081 Инструкция по эксплуатации онлайн [10/84] 73866

Connecting hot water

The inlet hose of the appliance can be also

connected to the hot water supply provided the

temperature doesn’t exceed 60°C.

In this case, both the wash cycle time and the

power consumption are reduced.

For hot water connection follow the same

procedure as that for cold water.

Connecting drain hose

x Connect the drain hose to the drain pipe 1,

diameter: 40 mm min., or let it run directly

into the sink 2.

Use the special plastic hose support which is

delivered with the appliance.

The free end of the hose must be at a height of 40

to 100 cm and must not be immersed. Make sure

that the hose is free from being bent or flattened.

Disconnecting from water supply and

sewerage

To disconnect the Aqua-Stop inlet hose, cut off

water supply by turning off the faucet, screw out

the nut of the safety inlet hose which adjusts it to

the faucet.

Put the hose into the special storage compartment

at the back of the dishwasher.

In case the free end of the hose is put directly into

the sink, pay attention to the following:

If the sink is mounted at the height of 100 cm from

the floor, the excess water cannot be drained

directly into the sink.

To drain the excess water from the hose in this

case, you need a pail or any other suitable

container which should be put below the sink at

the side of it.