Haier HB4800VD1V22 Инструкция по эксплуатации онлайн [10/16] 621103

ELECTRICAL CONNECTIONS

The required electrical power supply information is located on the series and rating plate

on the exterior of the unit. Wiring selection must be in accordance with local codes, or in

absence of local code, the National Electrical Code. A disconnect means should be installed

within sight of the unit, when required by code.

Copper wire is recommended for all electrical connections.

When an optional heat kit is installed refer to the electrical requirements in that kit.

The wiring diagram included in the heat kit must be placed over the wiring diagram on the

air handler.

All pertinent information, such as the rating plate, included in the optional heat kit must be

applied to the Air Handler as indicated.

The use of copper connections are recommended inside the control box (see UL 1995,

section 37.9).

WARNING

A MEANS OF STRAIN RELIEF MUST BE INSTALLED TO THIS APPLIANCE AT

THE ELECTRICAL SERVICE ENTRANCE.

When an optional electric heat kit is installed refer to the electrical requirements for that

kit. The ampacity and overcurrent protection shown above is only for "HB" air handlers

installed without a heat kit.

Model

No.

Min.

running

Ampacity

208/230

Max.

Over-current

208/230

Blower

Motor

FLA

Blower

Motor

H.P.

2 Ton 1.2/1.2 15/15 0.9 1/8

3 Ton 2.5/2.5 15/15 2.0 1/3

4 Ton 3.3/3.3 15/15 2.6 1/2

5 Ton 4.4/4.4 15/15 3.5 1/2

5 Ton -E 5.0/5.0 15/15 4.0 3/4