Home
Главная
Brayer
Кофеварка
BR1108
Инструкция по эксплуатации Страница: 10

Brayer BR1108 Инструкция по эксплуатации онлайн [10/80] 625010

Notes: this table has guide values of the amount of the

ready drink and is only used to select the volume of the

required cup.

RULES OF MAKING ESPRESSO

• Use fresh-ground co󰀨ee beans or ground co󰀨ee for

«espresso» co󰀨ee makers.

• Make even and slightly tamp the ground co󰀨ee in the

lter (21 or 22), you can do it with the back side of

the measuring spoon (23) (pic. 5, 6, 7).

• Strength of ready co󰀨ee depends on the quality and

grinding degree of co󰀨ee beans.

• If co󰀨ee is pouring out too long, this means the

co󰀨ee powder is too ne it is tamped too strongly; in

this case use coarse-ground co󰀨ee and choose the

tamping degree experimentally.

THERMOMETER (5)

• The built-in thermometer (5) shows the boiler

temperature, if the boiler temperature is over 80°С,

you can make co󰀨ee.

• When the co󰀨ee maker is not used, the thermometer

(5) will show the room temperature.

MAKING ESPRESSO

ATTENTION!

- Do not remove the lter holder (20) during making

co󰀨ee.

- Do not remove the lter holder (20) right after making

co󰀨ee, as there is redundant pressure inside, wait a

little before removing the lter holder (20).

• Remove the lid (12), remove the water tank (13).

• Fill the tank (13) with cold water, do not exceed the

maximal level mark, install the tank (13) back to its place.

• Install one of the co󰀨ee lters (21 or 22), depending on

the amount of ready co󰀨ee, into the lter holder (20)

matching the ledge on the lter (21 or 22) with the hole

on the holder (20) and turn the lter (21 or 22) counter/

clockwise.

• Add the required amount of ground co󰀨ee into the lter

(21 or 22) with a measuring spoon (23) and slightly tamp

the co󰀨ee in the lter (21 or 22) with the back side of the

measuring spoon (23) (pic. 5, 6, 7).

• Install the lter holder (20) into the installation place «

» and turn the handle (4) to the right as far as it will go «

» (pic. 2, 3, 4).

• Place a cup of suitable height and capacity (see the table

CHOOSING THE APPROPRIATE CUP) on the grid (2); if

you use small cups, take the pullout tray (3) by the lower

part and pull it towards yourself, place the cups on it.

• Insert the power plug into the mains socket (pic. 8).

• Note: - During preliminary heating, you can warm up the

cups that will be used for making co󰀨ee by placing them

on the tray (6).

• Switch the co󰀨ee maker on by setting the power switch

(11) «0/I» to the position «I», the indicator (7, 8, 9) will

light up and start ashing.

Brayer BR1108 Инструкция по эксплуатации онлайн [10/80] 625010

Содержание

Похожие устройства