AENO AGS0002 Инструкция по эксплуатации онлайн [7/70] 649075

www.aeno.com/documents 7

Connect the device to the mains by inserting the power plug into the power

outlet. Move the switch (7) to the "ON" position. The button indicator (6) will

light up and flash. Wait about 40 seconds for the steam to build up. Quiet

crackling during heating is allowed. The device is ready for operation when

the button indicator (6) lights steadily. Place the item to be steamed vertically

or horizontally. Point the nozzle away from yourself and those present, press

the steam button (6). Let out the first portion of steam on an inconspicuous

area of the product, as a few drops of water may come out. Then point the

nozzle at the surface to be steamed. When finished, press the steam button

(6) again. Turn the switch (7) to the OFF position to turn the unit off. Unplug

the unit and drain the remaining water from the water tank.

WARNING! When using it for the first time, check the operation of the device

on old clothing: it is possible that dust accumulated in the device during

transport and production may get in.

Note: For more efficient steaming in an upright position, it is recommended

to pull the garment lightly with your free hand and glove on (4) and slowly

move the steamer from top to bottom. When steaming horizontally, it is

recommended to move the steamer forward and backward.

Maintenance and cleaning

To clean the steamer wipe with a soft damp cloth. Do not use any detergents

or cleaning agents. Do not attempt to use any descaling agent, this will

damage the device. If you are in very hard water area, use distilled or bottled

water.

Troubleshooting possible malfunctions

 The device does not heat up. Possible reason: the device is not switched on

or not connected to the power supply. Solution: Make sure the unit is

turned on, the power plug is connected to the outlet, and the outlet is in

good condition.

 The device does not generate steam. Possible causes: low water level in the

tank; the unit is not turned on or not connected to the mains. Solution:

unplug the unit and fill the reservoir with water; make sure the unit is