Sinbo SJ-3138 Инструкция по эксплуатации онлайн [9/40] 83473

- 8 -

ATTENTION BEFORE USING

1. This machine is set with safety unit, when the handle does not fasten the cover or the

cutter seat is not fastened, the motor cannot turn, so as to ensure safety for the user.

2. When disassembling or assembling the juicer, press the upper of feed port of the cover

with your hand, then force the handle to slide in or out of cover slot.

3. When disassembling filter first remove the cover and pulp container , then turn the

middle ring up to 30 degrees by holding juicing spout with your hand ,and take up , the

filter will automatically leave the rotor

4. In order to avoid damage, before using, first check power supply for compliance with

rate voltage.

5. Clean all parts able to disassemble (refer to the section of “maintenance and cleaning”).

6. When assembling, please carefully read the diagram of “name and position of main

components”.

7. Please carefully rend the “attention” before using.

JUICING

1. Before using, please confirm the button switch of the main machine in stop state, in

this way, in case assembly is not completed, starting the main machine can be avoided,

so unnecessary damage for persons or property avoided.

2. Before juicing, first confirm filter and rotor clutched in position, and no hard contact

between filter cutter and transparent cover. Put the transparent cover on. Put the handle

into the cover slot, then turn on the machine.

3. For using, assemble according to the diagram of “name and position of main

components”. Turn on power supply, press switch to let the machine run no-load foe

5sec. Put prepared vegetable or fruit into feed port of the juicer .press with the pushing

bar, evenly, hard and slowly, juice of the vegetable or fruit can be found, original, fresh,

good for health.

4. Note: when pressing food with the pushing bar, force shall be even or indirect, pressing

force shall not be more than 1kg, no too sudden force, otherwise, juicing effect will be

reduced.

OPERATING TIME

This machine is designed with button switches of O speed ,I speed ,II speed (0 for stop

,I for weak speed ,II for strong speed ) For juicing , select strong speed for operating time

,after operating for 1 min stop for 1 min ,then use again ,After the above operation is

performed for three times , stop for 15 min ,do not operate until the motor is cooled ,in

this way ,service lift of this machine will be prolonged , the machine will serve you more

efficiently

ATTENTIONS

1. This machine is unavailable for the weakness, unresponsive or psychopathic person