Sinbo SS-4028 Инструкция по эксплуатации онлайн [8/47] 83934

- 7 -

HOW TO USE PRODUCT

Shaving

1. Press the button ON/OFF to start the shaver.

2. Make the shaver head part move quickly on the skin in straight lines and circles (Fig 6).

3. Cover the shaver’s protective cover after each use to avoid being damaged (Fig 7).

4. The shaver can run for ten days after a full charge.

(Remark: The indicator light will not change or turn off when it is fully charged.)

Trimming

Used for trimming temple and mustache.

1. Push the slide face upwards to open the hair trimmer, which can be started as the shaver start( Fig

CLEANING & MAINTENANCE

To ensure a better shaving effect, the shaver must be cleaned regularly.

The easiest and most sanitary way to clean the product is to wash the shaver head part and the whisker

storeroom with water each time after using it.

Do be carefully when using hot water.

Do remember to check the water is not too hot to avoid doing harm to hands.

1. Switch on shaver power supply.

2. Clean the four cutters and hair chamber by rinsing them directly under a water tap for some time

(Fig 9) and make sure the shaving cutters and the inside of hair chamber have been well cleaned.

3. After rinsing, switch off the power supply of shaver and shake off the moisture in shaving cutters/

You may also use the brush supplied to clean the hair chamber, and don’t use water here.

1. Turn off the shaver.

2. Open the four shaver blades one by one. (Fig 10) then rotate pull out the middle blade along the

direction of arrow above. (Fig 11).

3. Brush for cleaning the knife head and the knife net, hair storage room (Fig 12). (Note: the cutter head

to regularly remove the clean, because there is no exemption leak design)

4. Fit the razor head on shaving unit, first fitting the middle of the blade (Fig 13). Then assembling ide

four razor head (Fig 14). (Note:Aim the catching groove and press down. You will heard the clicking

sounds.)

Trimmer

Clean the trimmer each time after use.

1. Cut off the power supply for the shaver, then unplug the charger and also pull out the product’s plug

from the shaver.

2. Clean the trimmer with the brush included (Fig 15.)

3. Lubricate the trimmer teeth with a drop of sewing machine oil once every six months (Fig 16.)

Change

Change the shaver head once a year to get the best shaving effect. The shaver has a long service life

if not damaged for human factors.

The damaged or abraded shaver head can only be replaced with products SPEED-XL shaver head.

1. Turn the shaver off, and pull the damaged shaver head assembly out of the shaver (Fig 10,11)

2. Insert the new shaver head assembly into the groove on the shaver’s top. (Fig 13,14.)

Please refer to the point 2,4 of the washable design without knocking down shaver head.