Sinbo SSI-2876 Инструкция по эксплуатации онлайн [13/61] 84041

- 12 -

Faults-reasons and solutions

Iron emits an odor or smoke

Iron gives off an odor when turned on for the first time. Oils used during manufacture need to

be burnt off allow ten minutes for odor to disappear.

Iron does not heat

The iron should be plugged into a 230Volt, AC electrical outlet only. The temperature dial must

be set at the desired temperature.

Iron does not steam

The water tank many be empty. Turn the steam valve to “0” and add water .Allow the iron to

heat, and then set the steam dial to the steam setting.

Burst of steam feature does not work

The water tank must be at least 1/4 full .Temperature must be set to steam position. Iron should

be in the horizontal position. Prime pump briefly. Allow a short pause between shots. Be sure

to fully depress the burst of steam button.

Spray mist feature does not work

The water tank must be at least 1/4 full. Fill the iron as described in the section “how to fill the

water tank”.

Iron is leaking

The variable steam dial must be set on ” “,until the iron is hot . The temperature setting is too

low to produce steam. Shot of steam used too much, allow iron to re-heat.