Sinbo SSI-2875 Инструкция по эксплуатации онлайн [10/60] 84047

- 9 -

HOW TO USE

• Remove any labels, stickers or protective foil that may be attached to the body or soleplate

of the iron before first use.

• The iron may give off some smoke and emit an odor when you first use. This will cease after

a short while. It is safe and will hot harm the performance of the iron.

FILLING WITH WATER

• Remove the mains plug from the wall socket before filling the iron.

• Set the steam button to position “0” or “ ” and open the water inlet cover.

• Please fill your iron with normal tap water before using for the first time.

• Use the water beaker attached to fill clean tap water into water tank until “MAX” filling level.

• For refilling, you can also use tap water. However, if the water is very hard it is advisable to

use distilled water.

• Replace water inlet cover and dry the spilt water around the enclosure of the appliance.

• Do not fill the tank beyond the MAX indication.

• Do not put perfume, vinegar, starch, descaling agents, ironing additives chemically descaled

water or other chemicals in the water tank.

SETTING THE TEMPERATURE

Fabric Temperature control

NYLON/ACRYLIC/ACETATE •

SILK/RAYON/POLYESTER • •

WOOL/COTTON • • •

LINEN MAX

• Stand the iron on its heel and plug the power cord into wall socket.

• Turn the iron temperature control knob until you get the desired fabric/temperature setting.

We recommend using the above table as a guide.

• The temperature pilot light will light, indicating that the soleplate is heating up.

• When the pilot light goes out, the required temperature has been reached.

• The temperature pilot light will go on from time to time during ironing.

DRY IRONING

• For dry ironing, turn the steam control knob to “0”or “ ” .This will cut off the steam flow if

water is in the water tank.

• Turn the temperature control knob to select the desired fabric/temperature setting. The

indicator pilot light will light, put the iron on the smooth and stable place vertically.

• After the indicator pilot light goes out, you can begin to iron.

SPRAYING

• Ensure there is enough water in the water tank.

• Press the spray button to produce a fine spray of water nozzle and continue ironing.

NOTE: Do not spray silk.