Sinbo SVC-3471 Инструкция по эксплуатации онлайн [10/50] 84095

- 9 -

inlet facing downwards. Never place the appliance in any other position and never allow liquids

to come into contact with the motor.

a) Remove the appliance from its recharge seat (9).

b) Use the liquid suction attachment as final attachment (15); apply pressure to it to attach it.

c) Push the switch (2) forward to switch the appliance on.

d) Keep the appliance on with the suction inlet facing down at all times.

e) Pull the switch (2) back to switch the appliance off.

Note: Empty the container immediately after use and wash the filter.

Rinse the container and the filter in cold water and let all parts dry completely before reassembling

them.

Recharging the device

Insert the plug of transformer into the power outlet.

Make sure the on/off switch (2) is in OFF position (turned off).

Please recharge the appliance. When the appliance will be correctly positioned then the LED

will display a red light.

Note: when you are not using the device, keep it always placed in its recharge seat (9).

After 5 minutes of continuous use, the suction power may decrease.

Place the device in its seat and let it recharge for at least 2 hours.

If the device is used until the batteries are completely flat, it should then be recharged with a

complete recharging cycle of 14 consecutive hours.

Don’t let the device uncharged for a long time, because the inner accumulators may be damaged.

How to empty the container and clean the filter

Press the opening button (1) and unhook the dust container (14).

Remove the dust filter (7) from the inside of the container and empty the dust container (14).

Clean the motor filter and, if necessary, clean the inside of the container with a dry cloth.

Replace correctly the motor filter in the container.

Reassemble again the container and the body, inserting at first the lower part and then the

upper part, to obtain the complete closure

Note: After an intensive or long use, it is necessary to change the motor filter with a new one.

Don’t use the device if the motor filter is broken or worn out.

CLEANING AND MAINTENANCE

Before cleaning the device, always remove it from its seat and make sure it has completely

cooled.

The device should be cleaned with a dry cloth.

Don’t use abrasive detergents.

In order to avoid the risk of short circuit, don’t clean the device or its seat with wet cloths and

don’t use water.

Keep it in a dry and clean place.

Only the dust container (14) and the dust filter (7) can be washed in cold water. Let the parts

dry completely before reassembly.

Do not immerse the body of the appliance in water or other liquids.

Do not immerse the power supplier in water or other liquids.

Do not immerse the recharge seat or the transformer in water or other liquids.