Timberk T-WSS30-N41D-V Инструкция по эксплуатации онлайн [21/44] 684037

IM2022

6. DELIVERY SET

1. Water heater – 1 pc.

2. Anchor bolt – 2 pcs.

3. Safety relief valve – 1 pc.

4. Manual – 1 pc.

5. Warranty card – 1 pc.

6. Package – 1 pc.

**The design of the thermometer may be changed without prior notice. Depending on

the batch, the thermometer may be missing, which does not affect the performance of

the product.

7. INSTALLATION OF THE WATER HEATER

Site

1. The electric water heater must be installed on a solid wall.

2. The wall on which the electric water heater is installed must be strong enough to

support at least twice the weight of the heater filled with water, and the wall must be

free of cracks and other damage. Otherwise, measures must be taken to reinforce the

support or install the water heater on a special frame.

3. If the bathroom is too small, the heater can be installed elsewhere, out of direct

sunlight and away from humidity. However, in order to reduce heat loss in the pipes,

the heater should be installed as close as possible to where hot water is used.

4. When determining the site for the water heater, make sure the heater is easily

accessible by leaving at least 60 cm between the bottom of the water heater and the

floor, and at least 10 cm between the top of the water heater and the ceiling. This will

enable easy maintenance and adjustment as required.

WARNING!

The water heater must be installed on a vertical wall in a vertical position. If installed in

any other position or misaligned, the water heater will inevitably malfunction, causing

an emergency. This will be treated by the manufacturer as a non-warranty case.

Water heater installation

NOTE!

Please use the accessories provided by the manufacturer to install the water heater.

The electric water heater must not be mounted on the wall before you make sure that

the bracket is securely installed. Any failure to do so may cause the electric water

heater to fall off the wall, which may cause its damage and even major incidents

including bodily injuries. When marking spots for the anchor bolt holes, allow at least

60-cm clearance between the bottom of the water heater and the floor to ensure easy

maintenance when required.