Timberk T-WSS30-N41D-V Инструкция по эксплуатации онлайн [23/44] 684037

IM2022

WARNING!

Do not operate the water heater without a safety relief valve installed on the inlet

nozzle.

WARNING!

The pressure-relief device must be activated on a regular basis to remove the scale

and ensure proper operation.

WARNING!

A discharge pipe connected to the pressure relief device installed downwards direction

and in a frost-free environment.

NOTE!

No additional accessories, such as a shut-off valve, must be mounted between the

safety relief valve and the inlet nozzle.

WARNING!

If water in the installation place has significant content of calcium, manganese or iron

salts, it is necessary to install a suitable filter in the water supply system in order to

reduce the amount of scale in the tank and on the heating element.

Connection to the electric main

WARNING!

Before connecting the tank water heater, make sure the water heater is properly

grounded. Proper grounding is important to minimize electrocution and fire hazard. The

power cord is equipped with a plug with a grounding contact. The product must be

used with a properly grounded main socket.

WARNING!

Using a water heater without grounding is not safe for your life.

1. The water heater is designed to be connected to a 220-240V single-phase electric

main. Before connecting, make sure that the power supply at the site of connection

complies with the parameters indicated on the plate with the specifications of the

product. When installing the heater, comply with the applicable electrical safety

precautions.

2. The main socket must be designed for rated current of at least 10A and electric

cable with core cross section of at least 3x1.5 mm

(for copper).

3. The plug and socket must be kept dry to avoid electrical leakage.

NOTE!

Install the electric socket in places or on walls that may be splashed with water at a

height of at least 1.8 m.

Make sure that the electric plug is tightly connected to the socket on a regular basis.

Check it as follows: insert the electric plug into the socket, turn off the water heater

after 30 minutes of operation and remove the plug from the socket; check with your

hand whether the plug is hot. If the plug is hotter than 50 °C, replace the socket to

avoid damage, accidents, or fire due to poor electrical contact. Checks must be

conducted by a specialist.