Home
Главная
Timberk
Увлажнители Воздуха
THU UL 43 E
Инструкция по эксплуатации Страница: 17

Timberk THU UL 43 E Инструкция по эксплуатации онлайн [17/20] 707237

IM2020

9. CLEANING AND MAINTENANCE

 Before cleaning the appliance, make sure it is unplugged. Otherwise, it may result in electric shock.

 Before cleaning, in order not to burn your hands, wait until the water in the base of the appliance has

completely cooled.

 Use a damp and soft cloth to wipe the outside of the appliance.

 To avoid electric shock, do not scratch or damage the components of the device when cleaning.

 Do not use solvent, gasoline, dimethylbenzene, hard brush, talcum powder and other substances when

cleaning the device.

 Wipe off any remaining water inside the base of the unit under the tank with a damp and soft cloth.

 To remove water on small parts, you can use a brush and then wipe them again with a soft cloth.

 Clean the device once or twice a week.

 If dirt is formed on the membrane, clean it with a brush.

 Rinse the water tank cover and nozzle carefully and effortlessly with fresh water, otherwise this will

cause water to leak through the cover.

 After removing any remaining water from the surface of nozzle, wipe it with a soft cloth.

 Clean the outside of the appliance with a damp and soft cloth.

IMPORTANT!

 To avoid deformation of working surfaces, resulting in decreased atomizing or other malfunctions, do

not use metallic brushes, blades or talc powder to wipe the atomizer’s surface.

 The water tank may leak after heavy impacts.

 In case of water leakage, immediately stop using the unit and contact an authorized service center.

 To keep the unit dry, wipe the water after cleaning and dry the unit’s base and water tank. Make sure

that there is no water left inside the unit’s base and water tank.

 Before a long break in use, dry the base and the tank, but the tank on the base and pack the device in a

plastic bag, then put it in a box.

 Store the unit in a low-humidity room.

 Storing the unit undried results in generation of mold.

To clean the water tank and parts of the base of the device from salt deposits, use citric acid:

• for 1 liter of hot water, take 1 tablespoon of citric acid and mix well;

• pour the solution into the tank and put it on the base of the humidifier (water from the tank will automatically

fall into the base of the device);

• leave the humidifier for 10-12 hours - do not turn it on;

• after the time has passed, remove the solution from the device along with the exfoliated parts of the salt

coating;

• if it is difficult to remove plaque - use a special brush for the base of the humidifier (if this is not supplied,

you can use a toothbrush). For the tank - pour 0.5-1 cups of dry rice into cold water or a cooled citric acid

solution and shake until the plaque is peeled off;

• rinse all internal parts of the device with cool water;

• use a humidifier as usual after the procedure.

10. TROUBLESHOOTING

Malfunction

Possible cause

Solution

Poor atomizing (insufficient

productivity)

The unit is operating in

the low atomizing mode (low

atomizing frequency)

It is not a malfunction. Switch the

device into the intensive mode of

operation

The atomizer is clogged

Clean the atomizer.

Temperature of water in the

tank is low

Set maximum productivity mode.

The humidifier’s productivity will

go up after a while.

Timberk THU UL 43 E Инструкция по эксплуатации онлайн [17/20] 707237

Содержание

Похожие устройства