RST 02555 (meteo link IQ555) Руководство по эксплуатации онлайн [16/28] 732712

Note: Please note the polarity when inserting/replacing batteries in the unit, failure to do so

may result in permanent damage. Use good quality Alkaline Batteries and avoid recharge-

able batteries.

1 Insert two AAA batteries into the remote sensor. After the remote sensor is powered up, the sensor will trans-

mit weather data every 8s for 8 times. After this learning period is over, then the transmitter will transmit every

48s.

2 Insert two AA batteries into the weather station. When the base station is powered up all LCD segments will

light up for about 4 seconds before it enters into learning mode to learn the sensors security code. Every time

the remote sensor is powered up (for example after a change of batteries), a random security code is trans-

mitted and this code must be synchronized with the base station to receive weather data. Thus if battery

change happened on remote sensor side, then the base station must be power up again to re-learn the

transmitter.

3 Wait 3 minutes or until the outdoor temperature is displayed in the weather station. Do not press any keys

before outdoor sensor data received. The wireless weather station can receive up to 3 temperature sensors.

If you have purchased additional remote sensors, repeat step 1) for all extra sensors. However, ensure that

you leave 10 seconds in between the reception of the last sensor and the set-up of the following sensor. The

wireless weather station will number the sensors in the order of set-up, i.e. the first temperature sensor will

have the temperature displayed with 1.

4 Mount the units, ensuring that the receiver can still pick up the signal from the transmitter. To measure outdo-

or temperature, place the transmitter outdoors. It will transmit the temperature from its location.

Note: DO NOT PRESS ANY KEY on the base station until the first set of data is display on the LCD.

This ensures that the base station has synchronized with the sensors and that the system is now

functioning. If a key is pressed before the weather station receives the temperature signal,

you will need to follow the battery installation procedure again. Please wait 10 seconds befo-

re re-insert the battery again to make a proper reset for both transmitter and receiver.

Note: Please participate in the preservation of the environment by properly disposing of all

used-up batteries and accumulators at designated disposal points. Never dispose of bat-

teries in a fire as this may cause explosion, risk of fire or leakage of dangerous chemicals

and fumes.

RST02555 16

Installing the Batteries