Involight MH315TCOB Руководство по эксплуатации онлайн [4/8] 758767

connections with the mains with particular caution! Never touch them with wet hands .as this could lead

to mortal electrical shock. Never modify, bend, strain mechanically, put pressure on, pull or heat up the

power cord. Never operate next to sources of heat or cold. Disregard can lead to power cord damages,

fire or mortal electrical shock. The cable insert or the female part in the device must never be strained.

There must always be sufficient cable to the device. Otherwise, the cable may be damaged which may

lead to mortal electrical shock. Make sure that the power-cord is never crimped or damaged by sharp

edges. Check the device and the power-cord from time to time.If extension cords are used, make sure

that the core diameter is sufficient for the required power consumption of the device. All warnings

concerning the power cords are also valid for possible extension cords.

DESCRIPTION OF THE DEVICE

Features

> 11 channel DMX-512 .

> Pan :540°/tilt:180°.

> Variable electronic strobe.

> Variable electronic dimmer(0-100%).

> LED display menu with invert.

> Reset to factory settings option.

> Pan/tilt invert option.

> Fan cooled.

INSTALLATION

Rigging

The installation of the projector has to be built and constructed in a way that it can hold 10 times the

weight for 1 hour without any harming deformation.

IMPORTANT!OVERHEAD RIGGING REQUIRES EXTENSIVE EXPERIENCE, including calculating

working load limits, installation material being used, and periodic safety inspection of all installation

material and the projector. If you lack these qualifications, do not attempt the installation yourself, but

instead use a professional structural rigger. Improper installation can result in bodily injury and or

damage to property. The projector had to be installed out of the reach of people

DANGER OF FIRE! When installing the device, make sure there is no highly-inflammable

material(decoration articles, etc.)within a distance of min.0.5m.

DMX 512 connection/ connection between fixture

The wires must not come into contact with each other, otherwise the fixture will not work at all or

properly. Please note the starting address depends upon which controller is being used. Only use a

DMX cable and 3-pin XLR-plugs and connectors in order to connect the controller with the fixture or one

fixture to another