Involight MovingBeam410Q Руководство по эксплуатации онлайн [8/9] 759289

5. Master/slave Mode

When the LCD displays shows “SLAVE”, it enters the M/S mode.

D. SETTING

In the setting menu, press “SETUP” button enter to select the menu. There are 9 options, you may

select through “UP” and “DOWN” button.

1) BL Time: to set the LCD light time

2) Adjust: to set the motor restoration

3) Reset: to restore factory setting

4) Power: the voltage of power supply

5) Error: system self inspection

6) Lamp: LED information

7) Use: Time for use

8) Sensor: sensor setting

9) About: fixture information

a. When choose “BL Time”, press “SETUP” button to adjust the time: 5s, 10s, 20s, 30s, ON

through “UP” and “DOWN” button.

b. When choose “Adjust”, press “SETUP” button to select Pan, Tilt through “UP” and “DOWN”

button.

Pan: press “UP” and “DOWN” button to adjust “Pan” position until the pan is parallel with the

base. Press “SETUP” button, the display shows “Adjust Y/N”. Press “SETUP” button to adjust the

pan. Press “MODE” button back to the menu.

Tilt: press “UP” and “DOWN” button to adjust “Pan” position until the light is parallel with the

base. Press “SETUP” button, the display shows “Adjust Y/N”. Press “SETUP” button to adjust the

pan. Press “MODE” button back to the menu.

This function does not work when the fixture is under DMX mode or fail on position restoration.

c. When choose “Reset”, press “SETUP’ button to enter to factory resetting mode. Press “SETUP”

button again, LCD shows “Factory Reset”. Press “MODE” button back to the menu.

d. When choose “Power”, press “SETUP” button enter to check the information of power supply.

“Main” means the voltage of main board; “LED” means the voltage of LED driver.

e. When choose “Error”, press “SETUP” button enter to self-inspection. LCD shows “000000”

means approved. If not, press “SETUP” button to check the mistake.

f. When choose “Lamp”, press “SETUP” button to show the LEDs information