Ada GroundDrill 12 [7/34] Ground drill 12

GroundDrill - 12

MEASUREMENT FOUNDATION

GroundDrill - 12GroundDrill - 12

AUGER CHECKUP

1. Check parts are not loose nor missing. This goes especially for the spark

plug.

2. Check the air intake and outlet for clogging.

3. The auger uses an air-cooled engine. If the air passage is blocked, the

engine may overheat.

4. Check the air lter for dirt. A dirty air cleaner will cause the auger to

burn excess fuel.

5. Check the spark plug for spark.

ENGINE OIL

Caution: Oil is a major factor affecting performance and service life. Use

detergent oil. It’s not recommended to use vegetable-based uid. Check the

engine oil level with the engine stopped and in a level position.

Note: SAE 10W-30 is recommended for general use.Use oil SAE Synthetic

5W-30 when the average temperature in your area is within the recom-

mended range.

Check the engine with the engine stopped and in a level position.

1.Remove the oil ller cap/dipstick and wipe it clean.

2. Insert the oil ller cap/dipstick into the oil ller neck as shown, but do not

screw it in, then remove it to check the oil level.

3. If the oil level is near or below the lower limit mark on the dipstick.

Note: Don’t start engine if the oil level is below the lower limit mark. It

can damage the engine.

10W-30

5W-30

dipstick

upper oil level

low oil level