Ada GroundDrill-7 [7/30] Ground drill 5 7

MEASUREMENT FOUNDATION

GroundDrill - 5/7

Always shut-off engine before ll the fuel tank. Open fuel tank slowly. After lling the fuel

tank tight the tank cap.

Always keep the instrument 3 m away from the place where you are going to ll the fuel tank.

Clean the area around tank cap.

Starting engine

1. Move ignition starter switch to the ON position.(Pic.3)

2. Push several times on the primer bulb (4) (If you have it). When using the primer bulb, allow

the bulb to return completely to its original position between pushes. (Pic.4)

3. Pull return starter with a rapid full arm stroke.

4. After engine starts running, return throttle lever to the RUN position. Then pull again the

return starter (Pic.5).

NOTE! If the engine fails to start, repeat these steps 2-3 times.

Drilling

1. Hold handle tight with both hands (Pic.6)

2. Place the auger on the place where you are going to drill and start the engine.

3. If you feel unnatural vibrations or hear unwanted sounds, stop engine and check the

instrument.

4. Stop. Slow down the engine and move ignition starter switch to the STOP position. (Pic.7).

Pic.3

Pic.4