Fulgor Milano SHC 12011 RC X [7/32] Instructions for using maintaining and installing the hood

EN - 4

INSTRUCTIONS FOR USING, MAINTAINING AND INSTALLING THE HOOD

ATTENTION: The hood must only be installed by a qualified technician.

The company accepts no liability if it is installed by an unauthorised person.

Please read these instructions carefully before beginning the installation. Conserve this handbook together with the

hood

WARNINGS

Before cleaning or performing any periodic or urgent maintenance to the hood, ensure the power is turned off by

removing the plug from the socket and turning the main switch to 0 (off).

Do not connect the hood to any piping used for combustion appliances, such as burners, boilers or fireplaces.

Check that the main power supply corresponds to the voltage required by the hood, which is given on the silver label

stuck inside the hood. Ensure that the electric system is correctly earthed and that the earth discharge works cor-

rectly.

When cooking do not use any materials that could form high or unusual flames. Oil that has been used twice and fats

are very dangerous and could easily catch fire. Do not prepare flambè dishes under the hood. Respect local legisla-

tion and regulations issued by the relative authorities regarding the exhaust air when the suction is operating.

Failure to respect and perform all the maintenance operations described in this handbook could cause a fire hazard.

INSTALLATION

The minimum safety distance between the bottom of the hood and the top of the cooking hob must be 65 cm., smaller

distances must be previously authorised by the manufacturer. (see installation drawings)

The hood can be used for both filtering and suction.

When the filtering function is operating, i.e. with air recycle, carbon filters must be used (refer to the paragraph on

CARBON FILTERS).

When the suction function is operating, i.e. exhausting the filtered air on the outside, a suitable compensation system

must be used according to current standards in force. The diameter of the fume exhaust pipe must be the same or

greater than the diameter of the hood pipe union.

There must be sufficient ventilation in the room where the hood is installed, to allow the simultaneous use of other

appliances that use gas or other fuel.

ASSEMBLY INSTRUCTIONS

Attention: Before proceeding with the installation, make sure that the screws and the anchors already sup-

plied, are suitable for the type of wall the hood must be fixed to.

To assemble the hood use the accessories that are supplied and follow the instructions given in the enclosed hand-

book.

ELECTRIC WIRING

The electric wiring must be performed by a specialised electrician fully respecting current standards and legislation

in force.

Check that the power supply corresponds to the voltage requested by the hood, which is given on the silver

label stuck inside the hood.