Digitech CONTROL2 [12/20] Selecting banks

Selecting Banks

The Control 2 assigns groups of presets (called banks) to the numbered

footswitches. Each bank is a group of 5 presets (5 Patch Mode) or 10 presets

(10 Patch Mode) depending on the foot controller mode selected by the GSP.

Hence, there are 20 banks in 5 Patch Mode and 10 banks is 10 Patch Mode.

To select a new bank and a new preset, follow these steps:

Press either the Bank Down or Bank Up footswitch. The name of

the newly cued bank appears in the Display and the available preset

footswitches flash (1-5 in 5 Patch Mode and 1-10 in 10 Patch Mode).

Bank Down & Bank Up

To make the bank shown in the Display active you must load a new

preset by pressing one of the flashing preset footswitches. If no

footswitch is pressed within 5 seconds, the Control 2 will abort the

bank change and return to the preset prior to the bank footswitch being

pressed.

Banks are also changed when selecting presets using the Edit/Select knob

on the GSP. For example, if any of presets 1-5 are selected on the GSP in 5

Patch Mode, the bank titled Presets 1-5 will be the active bank on the

Control 2 and numbered Footswitches 1-5 would select presets 1-5. If preset

6 is then selected using the Edit/Select knob on the GSP, Presets 6-10

will now become the active bank and numbered Footswitches 1-5 would then

select presets 6-10.

Note that banks titled Presets 96-99 (5 Patch Mode) and Presets

91-99 (10 Patch Mode) contain only 4 and 9 presets respectively. When one

of these banks is selected, Footswitch 5 (5 patch mode) and the CONTROL

Footswitch (10 patch mode) have no function.

Using the Control 2 Remote Foot Controller



Control 2 Owner’s Manual