Boss DD-200 [15/18] Appendix

Returning to the Factory Settings

(Factory Reset)

Here’s how to return the DD-200 to its factory-set state.

1. While holding down the [ON/OFF] switch and

[MEMORY/TAP] switch, turn on the power

(insert a plug into the INPUT A jack).

The display indicates “FCt.”

2. Press the [MEMORY/TAP] switch.

The display indicates “Sur.”

If you decide to cancel, press the [MEMORY] button.

3. Press the [MEMORY/TAP] switch.

The factory reset is executed.

4. When the display indicates “FIn,” turn the

power o and on again.

Installing Batteries

Insert the batteries as shown below, being careful to

orient the batteries correctly.

* Batteries should always be installed or

replaced before connecting any other

devices. This way, you can prevent

malfunction and damage.

* If operating this unit on batteries, please

use alkaline batteries.

* Even if batteries are installed, the unit

will turn o if you connect or disconnect

the power cord from the AC outlet while

the unit is turned on, or if you connect or

disconnect the AC adaptor from the unit.

When this occurs, unsaved data may be

lost. You must turn o the power before

you connect or disconnect the power

cord or AC adaptor.

* When turning the unit over, be careful so

as to protect the buttons and knobs from damage. Also, handle the unit

carefully; do not drop it.

* If you handle batteries improperly, you risk explosion and uid leakage.

Make sure that you carefully observe all of the items related to batteries

that are listed in “USING THE UNIT SAFELY” and “IMPORTANT NOTES”

(leaet “USING THE UNIT SAFELY” and Owner’s manual).

* “Lo” will appear on the display if the batteries are low. Replace them

with new ones.

Appendix