Alto Uber PA [7/40] Troubleshooting

Troubleshooting

If the sound is distorted: Try lowering the volume control of your sound source, musical

instrument, or microphone. Also, try to reduce the overall volume of Uber using the Master

Volume knob.

If there is too much bass: Try adjusting the tone or EQ control on your sound source to lower

the bass level. This will allow you to play the music louder before clipping (distortion) occurs.

If there is a high-pitched whistling noise when using microphones: This is probably

feedback. Point the microphone away from the speaker.

If you can’t hear the microphone over the music volume: Turn down the music volume

from your source.

If you can't hear your instrument: Check the setting of the Line/Mic switch. If you are using

an instrument with passive pickups, set the switch to the Mic setting.

If you can’t play music from a flash drive: The USB port is only for charging USB devices.

RF Exposure Information

Maximum RF Power: Bluetooth (2402–2480 MHz): 5.32 dBm

The Maximum Permissible Exposure (MPE) level has been calculated based on a distance of d=20

cm between the device and the human body. To maintain compliance with RF exposure

requirement, use product that maintain a 20 cm distance between the device and human body.

Regulatory Conformance

Hereby, inMusic Brands, Inc. declares that the radio equipment type (ÜBER battery-

powered performance PA) is in compliance with Directive 2014/53/EU.

The full text of the EU declaration of conformity is available at the following Internet address:

altoprofessional.com/safety

Notice: Observe the national local regulations in the location where the device is to be used. This

device may be restricted for use in some or all member states of the European Union (EU).