![Behringer XENYX 1204USB Руководство по эксплуатации онлайн [5/15] 777628](/img/pdf.png)
Behringer XENYX 1204USB Руководство по эксплуатации онлайн [5/15] 777628
![Behringer XENYX 1204USB Руководство по эксплуатации онлайн [5/15] 777628](/views2/2009343/page5/bg5.png)
5 XENYX X1204USB/1204USB User Manual
LOW CUT
The mono channels of the mixing consoles have a high-slope LOW CUT lter for
eliminating unwanted low-frequency signal components (75 Hz, 18 dB/octave).
GAIN
Use the TRIM control to adjust the input gain. This control should always be
turned fully counterclockwise whenever you connect or disconnect a signal
source to one of the inputs.
COMPRESSOR
Each mono channel features a built-in compressor which lowers the dynamic
range of the signal and increases its perceived loudness. The loud peaks are
squashed down and the quiet sections are boosted.
Turn the COMP knob clockwise to add more compression eect. The adjacent LED
with light when the eect is engaged.
2.1.2 Equalizer
All mono input channels include a 3-band equalizer. All bands provide boost or
cut of up to 15 dB. In the central position, the equalizer is inactive.
The circuitry of the British EQs is based on the technology used in the best-known
top-of-the-line consoles and providing a warm sound without any unwanted
side eects. The result are extremely musical equalizers which, unlike simple
equalizers, cause no side eects such as phase shifting or bandwidth limitation,
even with extreme gain settings of ±15 dB.
Fig. 2.2: The equalizer of the inputchannels
The upper (HI) and the lower band (LO) are shelving lters that increase or
decrease all frequencies above or below their cut-o frequency. The cut-o
frequencies of the upper and lower band are 12 kHz and 80 Hz respectively.
Themid band is congured as a peak lter with a center frequency of 2.5 kHz.
2.1.3 Aux sends
Fig. 2.3: The AUX SEND controls in the channel strips
Aux sends take signals via a control from one or more channels and sum these
signals to a so-called bus. This bus signal is sent to an aux send connector and
then routed, for example, to an active monitor speaker or an external eects
device. The return from an external eect can then be brought back into the
console via the aux return connectors.
For situations which require eects processing, the aux sends are usually
switched post-fader so that the eects volume in a channel corresponds to
the position of the channel fader. If this were not the case, the eects signal
of the channel would remain audible even when the fader is turned to zero.
Whensetting up a monitor mix, the aux sends are generally switched to
pre-fader; i.e. they operate independently of the position of the channel fader.
Both aux sends are mono, are sourced after the equalizer and oer up to
+15 dB gain.
◊ If you press the MUTE/ALT 3-4 switch, aux send 1 is muted,
provided that it is switched post-fader. However, this does not
affect the aux send 2 of the X1204USB.
AUX 1 (MON)
In the X1204USB, aux send 1 can be switched pre-fader and is thus particularly
suitable for setting up monitor mixes. In the 1204USB, the rst aux send is
labeled MON and is permanently switched pre-fader.
PRE
When the PRE switch is pressed, aux send 1 is sourced pre-fader.
AUX 2 (FX)
The aux send labeled FX is for sending to eects devices and is thus set up to be
post-fader.
In the X1204USB, the FX send is routed directly to the built-in eects processor.
◊ If you wish to use the internal effects processor, the STEREO AUX
RETURN 2 connectors should not be in use.
◊ X1204USB: you can also connect an external effects processor to
aux send 2, however the internal effects module will be muted.
2.1.4 Routing switch, solo and channel fader
Fig. 2.4: Panorama and routing controls
PAN
The PAN control determines the position of the channel signal within the stereo
image. This control features a constant-power characteristic, which means the
signal is always maintained at a constant level, irrespective of position in the
stereo panorama.
MUTE/ALT 3-4
You can use the MUTE/ALT 3-4 switch to divert the channel from the main mix
bus to the Alt 3-4 bus. This mutes the channel from the main mix.
MUTE-LED
The MUTE LED indicates that the relevant channel is diverted to the submix
(Alt3-4 bus).
Содержание
- User manual 1
- X1204usb 1
- Table of contents 2
- Thank you 2
- Important safety instructions 3
- Legal disclaimer 3
- Limited warranty 3
- Before you get started 4
- Caution 4
- Control elements and connectors 4
- General mixing console functions 4
- Introduction 4
- Mono channels 4
- The user s manual 4
- Connector panel and main section 6
- Stereo channels 6
- Rear view of 1204usb x1204usb 9
- Cable connections 10
- Digital effects processor 10
- Installation 10
- Rack mounting 10
- Audio connections 11
- Caution you must never use unbalanced xlr connectors pin 1 and 11
- Connected on the mic inputs if you intend to use the phantom power supply 11
- Fig 4 xlr connections 11
- Fig 4 ¼ trs connector 11
- Fig 4 ¼ trs connector for headphones 11
- Fig 4 ¼ ts connector 11
- Please use commercial rca cables to wire the 2 track inputs and outputs 11
- Xenyx x1204usb 1204usb user manual 11
- You can of course also connect unbalanced devices to the balanced input outputs use either mono plugs or ensure that ring and sleeve are bridged inside the stereo plug or pins 1 3 in the case of xlr connectors 11
- Specifications 12
- Federal communications commission compliance information 14
- Xenyx x1204usb 1204usb 14
Похожие устройства
- Behringer MICROHD HD400 Руководство по эксплуатации
- Behringer ULTRA-DI DI400P Руководство по эксплуатации
- Behringer XENYX 1002B Руководство по эксплуатации
- Behringer MICROMON MA400 Руководство по эксплуатации
- Behringer MICROAMP HA400 Руководство по эксплуатации
- Behringer SONIC ULTRAMIZER SU9920 Руководство по эксплуатации
- Behringer MINIMIX MIX800 Руководство по эксплуатации
- Behringer SONIC EXCITER SX3040 Руководство по эксплуатации
- Behringer MINIFBQ FBQ800 Руководство по эксплуатации
- Behringer TUBE ULTRAGAIN MIC100 Руководство по эксплуатации
- Behringer EUROPORT EPA900 Руководство по эксплуатации
- Behringer EUROPOWER EP4000 Руководство по эксплуатации
- Behringer MICROPOWER PS400 Руководство по эксплуатации
- Behringer EUROPORT EPA40 Руководство по эксплуатации
- Behringer EUROLIVE WB215 Руководство по эксплуатации
- Behringer STUDIO CONDENSER MICROPHONE T-1 Руководство по эксплуатации
- Behringer DIGITAL MONITOR SPEAKERS MS40 Руководство по эксплуатации
- Behringer EUROLIVE PROFESSIONAL B1800X PRO Руководство по эксплуатации
- Behringer EUROLIVE PROFESSIONAL B1520 PRO Руководство по эксплуатации
- Behringer EUROLIVE B1520DSP Руководство по эксплуатации