Tcl 50P615 [6/40] Chapter 2 getting started

Chapter 2 Getting Started

Switching On

Follow the instructions on this page on how to switch on your TV set

and the remote control before going on to following pages describing

how to use the channel set-up procedure.

1. Insert two AAA batteries in the remote control.

Precautions on using batteries:

- Make sure you use the correct polarity.

- Do not mix new and used batteries.

- Do not use rechargeable batteries.

- Do not expose batteries to excessive heat such as sunshine,

them, as this could cause them to leak or explode.

- Remove the batteries from the remote control if you are not using

it for a long period of time.

- Attention should be drawn to the environmental aspects of battery

disposal.

2. Connect the power cable FIRST to the television, THEN to a mains

socket. (

Note

: If the power cable is connected to the television,

please only connect the power cable to the mains socket.)

Your TV set should only be connected to an AC supply. It must

not be connected to a DC supply. If the plug is detached from the

cable, do not, under any circumstances, connect it to a mains

socket, as there is a risk of electric shock.

Note:

3. Connect an outside aerial to the ANTENNA IN socket at the back

of the TV set.

The aerial socket (75 OHM - VHF / UHF / cable) can be used for

Note: If you want to receive the signal from your cable or cable

box, please connect a coaxial cable to the CABLE IN socket at the

back of the TV set.

4. When powered on, the TV will be turned on directly or be in

standby mode.

If the power indicator lights up, the TV set is in standby mode.

Press the

button on the remote control or on the TV set to turn

on the TV.

Switching Off

• To put the TV set into standby mode, press the button on the

remote control. The TV set remains powered up, but with low

energy consumption.

•

outlet.