Jacky\'s JR FV568EN [40/66] Installing and operating your fridge

EN -39-

• compartment as they can bur󰀬 as the contents freeze.

• Do not place explosive or ammable material in your fridge. Place drinks

with high alcohol content vertically in the fridge compartment and make

sure that their tops are tightly closed.

• When removing ice from the ice-making compartment, do not touch it.

Ice may cause fro󰀬 burns and/or cuts.

• Do not touch frozen goods with wet hands. Do not eat ice-cream or ice cubes immediately

after you have taken them out of the ice-making compartment.

• Do not re-freeze frozen goods after they have melted. This may cause health issues

such as food poisoning.

• Do not cover the body or top of fridge with lace. This a󰀨ects the performance

of your fridge.

• Secure any accessories in the fridge during transportation to prevent damage

to the accessories.

• Do not use plug adapter.

In󰀬alling and operating your fridge

Before 󰀬arting to use your fridge, you should pay attention to the following points:

• The operating voltage for your fridge is 220-240 V at 50Hz.

• We do not accept responsibility for any damages that occur due to ungrounded usage.

• Place your fridge where it will not be exposed to direct sunlight.

• Your appliance should be at lea󰀬 50 cm away from 󰀬oves, gas ovens and heater cores,

and at lea󰀬 5 cm away from electrical ovens.

• Your fridge should never be used outdoors or exposed to rain.

• When your fridge is placed next to a deep freezer, there should be at lea󰀬 2 cm between

them to prevent humidity forming on the outer surface.

• Do not place anything on your fridge, and in󰀬all your fridge in a suitable

place so that at lea󰀬 15 cm of free space is available above it.

• Use the adju󰀬able front legs to make sure your appliance is level and 󰀬able.

You can adju󰀬 the legs by turning them in either direction. This should be

done before placing food in the fridge.

• Before using your fridge, wipe all parts with a solution of warm water and

a teaspoon of sodium bicarbonate, then rinse with clean water and dry.

Place all parts in the fridge after cleaning.

If your refrigerator has a fan condenser:

The condenser of your fridge is placed at the

bottom of cabinet. As a result of that, assemble

the spacer by xing it to holes on the cover

bottom panel and turn 90° that’s shown below

gure for arranging the di󰀬ance between the

refrigerator and the back wall at where you

place the fridge. You can move the fridge

towards the back wall until that point.

Pla󰀬ic for di󰀬ance setting