Remez RMVС-553 [10/20] Assembling the appliance
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Remez RMVС-553 [10/20] Assembling the appliance

Remez RMVС-553 [10/20] Assembling the appliance
ENG
1. Disassembly and installation of the handle
1.1. Installation
Insert the connecting tube of the handle into the
hole on the body of the appliance, as shown in figure.
1.2. Disassembly
Use a screwdriver of the correct size or Allen key,
insert it into the thin hole located at the top rear of
the case and press while lifting the handle upward.
ASSEMBLING THE APPLIANCE
CONTROL OF THE WASHING VACUUM CLEANER
Press the button to turn the vacuum cleaner on
and off.
To switch between operating modes, press the
ECO/MAX button.
There are two operating modes Eco and Turbo
for efficient daily cleaning of the whole house.
Turn on/off
Switching operating
modes
Turbo mode
Turbo mode - allows you to remove stubborn
dirt on any surfaces.
Suction power — 12 000 Pa
Battery life — 40 minutes
Eco mode
Eco mode - provides continuous cleaning of
the room.
Suction power — 8 000 Pa
Battery life — 45 minutes
To spay clean water, press the button on the
handle of the vacuum cleaner.
A one-second press sprays 10 milliliters of
water under a pressure of up to 3 atmospheres
to the rotating roller brush.
Pressing for 5 seconds allow you to clean an
area of about 5 m
2
.
More moisture - for stubborn dirt.
Less moisture - for delicate coatings.
Clean water spray
button
Clean water spray
Turning on/off of the voice assistant
To turn on/off the voice assistant function,
press the button located on the back of the
vacuum cleaner body.
Turning on/off of the
voice assistant
Full of water
Lack of water
Self-cleaning
Spray water Battery
MAX ECO
Display
D i s p l a y va l u e s Colour indicator
When a certain mode is turned on, the
corresponding indication lights up
Red light: Water shortage
White light: Eco mode
Blue light: Turbo mode
Green light: Self-cleaning mode
Modes of operation
Time until the end
of work
The tank is full
of water
Fill the tank for
clean water
Self-cleaning
Water spray
Battery
Installation and filling of the clean water tank.
1. Pull the clean water tank
upwards to remove it from the
appliance.
2. Unscrew the cover
located on the tank
counterclockwise.
3. Fill in running non-hot water
to the level indicated on the
tank - WATER. If desired, add
REMEZair detergent to the
level indicated on the tank -
DETERGENT.
4. Screw the cover on
clockwise.
5. Turn the tank over and place
it on the vacuum cleaner
until it clicks
NOTES ON FILLING THE CLEAN WATER TANK
Fill the tank with not very hot (no more than 40°C) tap water.
DO NOT FILL BOILING WATER.
DO NOT HEAT THE WATER OR TANK IN A MICROWAVE OVEN.
ВОДА
ВОДА
WATER
DETERGENT

Содержание

Похожие устройства

Скачать