INGCO BMS14007 [7/17] Warning this power tool produces an electromagnetic field during operation this field may under some circumstances interfere with active or passive medical implants to reduce the...

Residual risks

Even when the power tool is used as prescribed it is not possible to

eliminate all residual risk factors. The following hazards may arise in

connection with the power tool’s construction and design:

a) Health defects resulting from vibration emission if the power tool is being

used over longer period of time or not adequately managed and properly

maintained.

b) Injuries and damage to property to due to broken accessories that are

suddenly dashed.

Warning! This power tool produces an electromagnetic field during

operation. This field may under some circumstances interfere with active or

passive medical implants. To reduce the risk of serious or fatal injury, we

recommend persons with medical implants to consult their physician and the

medical implant manufacturer before operating this power tool.

the fence.

l) Provide adequate support such as table extensions, saw horses, etc. for a

workpiece that is wider or longer than the table top . Workpieces longer or wider than

the mitre saw table can tip if not securely supported. If the cut-off piece or workpiece tips,

it can lift the lower guard or be thrown by the spinning blade.

m) Do not use another person as a substitute for a table extension or as additional

support. Unstable support for the workpiece can cause the blade to bind or the workpiece

to shift during the cutting operation pulling you and the helper into the spinning blade.

n) The cut-off piece must not be jammed or pressed by any means against the spinning

saw blade. If confined, i.e. using length stops, the cut-off piece could get wedged against

the blade and thrown violently.

o) Always use a clamp or a fixture designed to properly support round material such

as rods or tubing. Rods have a tendency to roll while being cut, causing the blade to

“bite” and pull the work with your hand into the blade.

p) Let the blade reach full speed before contacting the workpiece. This will reduce the

risk of the workpiece being thrown.

q) If the workpiece or blade becomes jammed, turn the mitre saw off. Wait for all

moving parts to stop and disconnect the plug from the power source and/or remove

the battery pack. Then work to free the jammed material. Continued sawing with a

jammed workpiece could cause loss of control or damage to the mitre saw.

r) After finishing the cut, release the switch, hold the saw head down and wait for the

blade to stop before removing the cut-off piece. Reaching with your hand near the

7|English

) Hold the handle firmly when making an incomplete cut or when releasing the switch

efore the saw head is completely in the down position. The braking action of the saw

ay cause the saw head to be suddenly pulled downward, causing a risk of injury.