Stingray ST-OH1001B черный жемчуг [8/12] Gbr user manual

8

GBR USER MANUAL

CAUTION

When using any electrical appliance, basic safety precautions should always be followed, including the following:

To ensure familiarity with the controls, safety features, and operation of your heater, read all instructions before use.

 Danger of electric shock exists even when the appliance is switched off. ALWAYS unplug the unit when not in use.

or instruction concerning use of the appliance by a person responsible for their safety. Close supervision is required when any appliance is used by or near children.

 The surface temperature of the flanges is higher, during use, thus closely supervise any children in the area of this appliance.

 If malfunctions happen during operation, please put it to nearby appointed service center with the maintenance card. Never disassemble it by yourself.

 To avoid a circuit overload, do not operate another high wattage appliance on the same circuit.

 The heater must always operate in vertical position.

 Do not scrap the surface with rod or sharp hard tools, as this may cause deformation and rust because of damage of paint coat.

 During use surface temperature of the flanges is perhaps higher, thus do not touch it except handle, knob and the keys.

 Never use the unit in places with not flat and unstable surfaces. Make sure there are no flammable or easy deformed objects within 1m.

 The heater is suitable for operation on an A.C. electricity supply having the same voltage as that shown on its rating label. The unit should be earthed.

 Do not cover the appliance. CAUTION! Do not cover the heater while it is on. This can cause dangerous temperature increase.

In order to avoid the risk of damage to the components of the device, a safety system is installed in it, which, when the maximum permissible temperature is reached, automatically turns off the device. If the

device overheats, follow these steps:

 Set the operating mode switch to the "O" position and disconnect the appliance from the mains.

 Allow the appliance to cool completely for a few minutes before turning it on again.

 Eliminate the cause of overheating of the device.

 Connect the appliance to the mains and switch the mechanical switch (4) to the "I" position (ON) and select the maximum power mode and set the maximum temperature.

 If the appliance does not turn on or does not function normally, disconnect it from the mains immediately and contact the nearest service center with qualified specialists for troubleshooting.

CLEANING AND MAINTENANCE

 Always un-plug the heater from the wall socket and allow it to cool down before cleaning.

 Clean the outside of the heater by wiping with a damp cloth and buff with a dry cloth.