Marta MT-2451 черный жемчуг [8/12] Assembling

8

 The heater must always operate in vertical position.

 Do not scrap the surface with rod or sharp hard tools, as this may cause deformation and rust because of damage of paint coat.

 During use surface temperature of the flanges is perhaps higher, thus do not touch it except handle, knob and the keys.

 Never use the unit in places with not flat and unstable surfaces. Make sure there are no flammable or easy deformed objects within 1m.

 The heater is suitable for operation on an A.C. electricity supply having the same voltage as that shown on its rating label. The unit should be earthed.

ASSEMBLING

 Before using the heater, the feet (supplied separately in the carton), must be fitted to the unit.

 These are to be attached to the base of the heater using the 4 self-tapping screws provided, taking care to ensure that they are located correctly in the bottom ends of the heater side moldings.

USING APPLIANCE

NOTE: It is normal when the heaters are turned on for the first time or when they are turned on after having not been used for a long period of time the heater may emit some smell and fumes. This will

disappear after a while.

 Choose a suitable location for the heater, taking into account the safety instructions above.

 Before connecting the unit to the power supply, set the thermostat controller to the leftmost «-» position.

 Insert the plug of the heater into a suitable socket.

 Turn the thermostat knob fully in a clockwise direction to the maximum setting.

 To turn off the heater, turn the thermostat controller to the leftmost position and the heating mode switches to the off position, only then disconnect the unit from the power supply.

 Disconnect the appliance from the power supply. Do not pull on the wire, only hold on to the plug. Always allow the appliance to cool down completely before you put it away.

 To avoid damage to the unit, nothing should prevent the air vent system from functioning.

CLEANING AND MAINTENANCE

 Always un-plug the heater from the wall socket and allow it to cool down before cleaning.

 Clean the outside of the heater by wiping with a damp cloth and buff with a dry cloth.

 Do not use any detergents or abrasives and do not allow any water to enter the heater.

 When the heater is not used for long periods of time it should be protected from dust and stored in a clean dry place.

SPECIFICATION