Scarlett S4 (SC 21.1005 S4) Руководство по эксплуатации онлайн [18/40] 794296

IM2022

IMPORTANT!

1. Switch on and operate the radiator only when it is in vertical position (with wheels

below and control elements above). Any other position may cause a dangerous

situation and result in failure of the oil-filled radiator or damage of property. The

manufacturer will consider this as a non-warranty case.

2. Do not switch the radiator on, if roller wheels are not installed.

8. OPERATION OF THE DEVICE

1. Before starting to use the device read section «Safeguards».

2. Connect the unit’s power cord to an electric outlet, observing all of the mentioned

precautions. Remember that you can connect the unit to electric mains only if the

power mode knob is in “0” position, which means the knob should be rotated against

the stop counterclockwise.

3. It is also preferable to turn the thermostat knob against the stop counterclockwise.

Then you can connect the unit to electric outlet.

4. Set the unit’s power mode knob to position “I”, “II” or “III” (low, medium and

maximum heating power respectively). Remember that the higher heating power you

choose, the faster the unit heats the air. But at a low power you save electric power

and reduce the load on your electric mains.

5. After you chose operating heating power, you need to choose heating

temperature. Turning the thermostat knob clockwise (from MIN position to MAX

position), you adjust the temperature you need. After you choose the temperature (and

after you chose heating power mode, see 4.) the oil-filled radiator will start to heat.

6. During the first minutes of radiator’s operation you may fell a slight smell of burning.

It may be caused by dust on the unit; it will soon disappear. If necessary, you can

clean the unit, following rules in this manual and observing «Safeguards».

7. When the room temperature will reach the desired level, you should slowly turn the

thermostat knob counterclockwise (towards MIN). You will hear a click of the

thermostat turning off, and the light on the control panel will go out. Now the room

temperature will be maintained at the chosen level.

8. If you need to reduce the room temperature, turn the thermostat knob

counterclockwise. Also you can lower the unit’s operating power (I or II).

9. If you need to increase the room temperature, turn the thermostat knob clockwise

(maximum possible position is MAX). Also you can increase the unit’s operating

power (II or III).

10. To turn off the radiator, set the power mode knob to “0” position and disconnect the

device from the mains by unplugging the plug from the outlet.

IMPORTANT!

For the correct operation of the unit, the level of voltage in electric mains must be

sufficient in strict compliance with the technical parameters indicated on the unit. See

the technical label, as well as all labels with special warnings, attached to the unit.