AENO ATB0003 Руководство по эксплуатации онлайн [11/148] 794917

aeno.com/documents 11

blender blade use the brush . Before plugging in, make sure that the

bowl is securely seated on the blender base and that the bowl lid is closed.

Preparing for operation

Wash the blender bowl , the large lid and the small lid with warm

soapy water and wipe it dry before the first use and each subsequent use.

WARNING! Never allow water to get to the bottom of the blender bowl base

. Short circuit of electrical contacts will occur and the device will break down.

Place the bowl on the blender housing (See picture d). The bowl

connector must fit into the groove of the blender body . The motor shaft

connector must fit into the blade shaft connector on the bottom of the bowl

base . The rubber compensators must fit into the recesses of the bowl

base.

NOTE. If the bowl can not be installed on the blender housing, remove it from

the base and twist the motor shaft connector in the blender housing by

hand half a turn in either direction.

Operating the device

Place food in the bowl . Then place the large lid on the bowl and turn it

clockwise until the grooves on the large lid align with the protrusions on the

bowl (See figure b). After that insert the small cap into the large cap

and turn it clockwise (See picture c). To open the large and small lids turn them

counterclockwise.

NOTE. The device will immediately stop working if you open the large lid. If you

need to add food or spices while the blender is running, you can open the small

lid to do so. Use the measuring cup to dose spices and other products. You

can find recipes of various dishes in the full instructions at

aeno.com/documents.