Home
Главная
Brayer
Термопоты
1091BR
Инструкция по эксплуатации Страница: 8

Brayer 1091BR Инструкция по эксплуатации онлайн [8/44] 795016

and the thermopot will be switched to the keep warm

mode, the keep warm indicator (19) «85» will light up.

The water temperature 85°С is set by default.

Notes: the thermopot uses a long boiling technology

which signicantly reduces the chlorine level in water.

• To avoid burns by hot steam, do not bend over the

steam release openings (7) in the thermopot lid (5).

Do not block the steam release openings (7) with any

objects.

• Drain the water after the rst boiling. Hot water

resulting from the rst boiling is not recommended to

consume, you may use it for domestic needs.

ATTENTION!

Be careful when pouring out water to avoid burns

by hot water.

• Unlock the activation of the water pump by pressing

and holding the «Lock» button (18) within 5 seconds,

the indicator (17) will light up.

• To drain the water you can do the following:

First option: place a suitable bowl, for instance, a cup

under the spout for pouring water (3) and press the

water (2) dispense button with a rim of the cup (pic. 3).

Second option: place a suitable bowl under the spout

for pouring water (3) and press and hold the water

dispense button (16) «Water dispense», after the cup is

lled release the button (16).

Notes:

- the water is dispensed only when the indicator (17) is

switched on; if you pressed the button (18) «Lock» and

didn’t do anything, in this case the indicator (17) will go

out in 10 seconds;

- if you haven’t used the thermopot for a long time,

the water dispense may malfunction. In this case it

is recommended to open and close the lid (5) and to

switch the water dispense on again.

• To switch the thermopot o disconnect the power

cord (22) plug from the mains socket.

• Open the thermopot lid (5) and wait until it cools

down completely.

• Always drain the remaining water from the thermopot

ask, to do this remove the lid (5).

• Before removing the lid (5) slightly open it at the

angle of approximately 45°, and pull the lid (5)

towards the control panel (4) (pic. 2).

• Carefully tilt the thermopot to drain the remaining

water (pic. 3).

• Install the lid (5) to its place; to do this, set the lid

(5) at the angle of approximately 45° and insert

the lid (5) to its installation place; before using the

thermopot make sure that the lid (5) is xed properly.

Additional information

• The thermopot is equipped with rotating base (12).

You can turn the thermopot body (10) in the required

direction.

Brayer 1091BR Инструкция по эксплуатации онлайн [8/44] 795016

Содержание

Похожие устройства