Home
Главная
Brayer
Конвекторы
BR4881
Руководство по эксплуатации Страница: 7

Brayer BR4881 [7/36] Automatic emergency switch off function if the outgoing air is too hot

7EN

USING THE CONVECTION FAN HEATER

• Place the convection fan heater vertically on an even

dry moisture- and thermal-resistant surface, do not

place it horizontally and do not turn it over.

• Do not place the convection fan heater on soft

surfaces, such as carpets with high pile, sofas or

beds.

• The distance between the convection fan heater and

the furniture should be at least 1 m.

• To avoid mains overloading, do not switch on several

electrical appliances with high power consumption at

the same time.

• Insert the power plug into the mains socket.

• Set the operation mode switch (3) into the necessary

position:

- «0» – the unit is o󰀨;

- « » – low power (1000 W);

- « » – maximal power (2000 W).

• • Turn the thermostat control knob (4) clockwise to

the maximum position «МАХ»; the light indicator (5)

will light up. When the desired air temperature in the

room is reached, turn the thermostat control knob

(4) counterclockwise until a distinctive click, while

the light indicator (5) goes out, in this position of the

thermostat the set air temperature in the room will be

maintained.

• To increase the air temperature in the room, turn the

thermostat knob (4) clockwise and counterclockwise

to decrease it.

Note: - the fan heater will not switch on if the thermostat

settings correspond to the air temperature in the room.

• After the unit operation is nished, turn the

thermostat control knob (4) counterclockwise as far

as it will go and set the operation mode switch (3) to

the position «0» and unplug the unit.

Note: - when you switch the unit on for the rst time,

some smoke or foreign odor may appear. It is normal

and not covered by warranty.

AUTOMATIC EMERGENCY SWITCH-OFF

FUNCTION IF THE OUTGOING AIR IS TOO

HOT

• If the outgoing air temperature exceeds the

acceptable value, the automated thermal switch will

switch o󰀨 the convection fan heater.

• Set the operation mode switch (3) to the position

«0» and unplug the unit, let the unit cool down

for approximately 15-25 minutes (the waiting time

depends on the room temperature), and only then

you can switch it on again.

• Make sure that the upper and bottom air grids are not

blocked with foreign objects.

• Insert the power plug into the mains socket and

switch the unit on.

• If the convection fan heater does not switch on, it

may be caused by another malfunction. In this case

apply to a service center for repairing of the unit.

Brayer BR4881 [7/36] Automatic emergency switch off function if the outgoing air is too hot

Содержание

Похожие устройства