KRAFT TCH-UME7201W [33/76] Automatic washing machine

user guide

AuTOMATiC WAsHiNg MACHiNe

washing machine and secure the hose by twisting it clockwise.

• If there is one inlet valve on the back of the washing machine, it must be connected

to a cold water source.

• If there are two intake valves, they are connected to the cold and hot water supply

sources.

ATTENTION! Do not bend the hose. Check the connection of the water inlet

hose every time before using the washing machine.

CONNECTING THE WATER DRAIN HOSE

• The drain hose must be located at a height of 65-100 cm above the floor level,

otherwise it may lead to poor slow draining.

• Use the drain hose bracket (not included) for mounting. Make sure that all hose

connections are sealed.

ATTENTION! The end of the drain hose must not be submerged in water,

otherwise it may malfunction.

CONNECTION TO THE POWER SUPPLY NETWORK

This appliance is equipped with a grounded plug installed on the power cord. There-

fore, it must be connected to an appropriate electrical outlet to protect against short

circuits. The installation, connection and grounding of the electrical system must comply

with the provisions of European standards, as well as applicable local regulations. The

ground cable must not be interrupted by the switch. If your apartment does not have a

ground connection, contact a qualified electrician to install it.

ATTENTION! The power outlet should be freely accessible, and the washing

machine should be easily connected to the power grid.

• The maximum current when using the washing machine is 10 A, make sure that

the power supply system (current, voltage and wiring) in your home can meet the

requirements of a working washing machine. Make sure that the mains supply

voltage corresponds to the rated voltage of the machine (220V).

• Connect the washing machine to an outlet that is properly grounded. In the event of

a short circuit, grounding can reduce the risk of electric shock. The power plug must

match the power outlet.

• Do not plug in or pull out the plug with wet hands.

• When pulling out the plug, always hold it, carefully removing it from the socket. Do not

pull the power cord.