Oursson RF0480/WH [14/60] Cleaning and maintenance рiс f

Oursson белый RF0710/WH [14/60] Cleaning and maintenance рiс f
14
TRANSPORTATION, Рiс. E
Make sure there are no children or animals in the
device.
Move and transport the device only in the un-
loaded condition.
It is recommended to move and place the device
in two, Pic. E-1
Pack the device before moving it.
When moving do not grab or pull the door or door’s
handle.
When moving the device you cannot tilt it more than on
45 degrees. Protect the device from excessive vibration
and hits. Pic. E-2.
Please transport the device packed and in vertical po-
sition. Improper transportation may result in injury and
damage of the device.
POSSIBLE PROBLEMS AND SOLUTIONS
Possible problems Possible causes Solutions
Device isn’t working.
There is no voltage in the mains.
The cord is plugged incorrectly.
Turn on the device.
Check the main and the plug. If they are
working, call the service center.
Vibrating noise . The device is in unstable position.
Adjust the position of the device.
Move it if necessary.
The temperature is not cold
enough
The door is not closed rmly.
Not enough ventilation
Make sure the door is rmly closed.
Clean the vents.
The compressor is operating for
a long period.
Ambient temperature is too high.
The door is opened too often or
remains open.
Adjust the temperature of the room.
Make sure the door is rmly closed.
Frost accumulated on the rear
side of the device.
There is hot or moisture food in
the device.
High humidity of the
environment.
Do not place hot or unpacked products into the
device.
Adjust the humidity in the room.
Please check the possible problems before contacting a service center.
Reversing the door, Pic D-4
1
2
3
4
5
6
7
8
Top hinge cover
Top hinge screw
Top hinge
Cabinet plug
Bottom hinge
Door handle plug
Bottom hinge screw
Leveling leg
1. Remove top hinge cover
1
and top hinge screws
2
which are below it. Then remove top hinge
3
.
2. Remove cabinet plugs
4
and door handle plug
6
.
3. Remove the door.
4. Remove right and left leveling legs
8
.
5. Remove the bottom hinge
5
and bottom hinge screws
7
.
6. Install the bottom hinge
5
on the other side of the lev-
eling legs with bottom hinge screws
7
.
7. Install right and left leveling legs
8
. There are two
holes below the refrigerator to t the two levelling legs.
8. Install the door.
9. Install the top hinge
3
on the other side with top hinge
screws
2
.
10. Install top cover
1
above the top hinge and install
cabinet plugs
4
and door handle plug
6
on the other
side.
11. Adjust the leveling legs
8
.
Note: Dont tilt the appliance over 45° when revising the
door as possible damage to the sealed system may occur.
CLEANING AND MAINTENANCE, Рiс. F
Unplug the device.
Wash the inner parts of the device with a soft cloth and
clean water with a detergent, then wipe everything with
a cloth and clean water and wipe dry.
Contamination of the door gasket can cause damage
to it, so regularly clean it with a soft cloth and a small
amount of neutral detergent.
Outer surface of the device must be cleaned with a
slightly damp or dry cloth.
Do not rub with detergent the informational sticker in-
side the device, because printed information can be
erased. The information is necessary for service.
Do not spill water on the electrical components of
the device, as well as air vents because of the dan-
ger of electric shock.

Содержание

Похожие устройства

Скачать