Beon BN-3413 черный [11/16] Instruction manual

11 INSTRUCTION MANUAL

NOTE:

When first used, the water may have a slight plastic smell. Itis better to drain the water after the

first boiling. In the future, the smell of plastic will disappear.

ATTENTION!

Make sure that the water does not fall below the minimum level mark on the water level scale

during the operation of the thermos flask. As soon as this happens, immediately disconnect the

thermopot from the power supply, and after it cools down, add water to the reservoir.

CLEANING AND MAINTENANCE

 Disconnect the thermos bottle from the power supply and wait for it to cool down.

 Open the lid and drain the remaining water.

 Wipe the instrument body with a slightly damp cloth.

 Wipe dry lid and silicone sealer.

CLEANING THE INTERNAL TANK

 Wipe the inner tank with a sponge.

 If scale has formed on the tank walls that cannot be removed with a sponge, perform descaling:

- Fill the tank with water to the maximum mark and add citric acid (30-50 g). Turn on the

thermopot and boil the water. After that, let it run in the heat retention mode for another

hour.

- Then disconnect the thermopot from the power supply and let it cool down.

- Drain and clean the tank walls with a nylon brush, then rinse with clean water.

Over time, silicone gaskets may lose their flexibility and become rigid, causing steam to leak out

from under the closed lid or disrupting the operation of the mechanical pump. In this case, the sealing

gaskets should be replaced.