Rondell RDE-1970 Инструкция по эксплуатации онлайн [11/24] 810714
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Rondell RDE-1970 Инструкция по эксплуатации онлайн [11/24] 810714

Rondell RDE-1970 Инструкция по эксплуатации онлайн [11/24] 810714
11
ENGLISH
•
If you do not use the ice maker for a long time, unplug
it and clean.
SELF-CLEAN FUNCTION
• Before switching the self-clean mode on, open the drain
opening (9) plug and drain the remaining water. Install
the plug (9) back to its place.
• Fill the water tank with clean drinking water.
• To switch the self-clean mode on, press and hold the
button (14) for 3 seconds. The pump will start pumping
water from the water tank into the ice basket.
• After the self-clean process is finished (in approximately
10 minutes), the unit will switch to standby mode.
• Clean the unit as described in the chapter «CLEANING
AND CARE».
• You can also press the button (14) during the pump oper-
ation to exit the self-clean mode.
CLEANING AND CARE
ATTENTION!
– Unplug the unit before cleaning.
– Do not use mechanical devices or other means to accel-
erate the thawing process, other than those recom-
mended by the manufacturer.
– Do not immerse the power cord and the unit into
water.
• Open the lid (2) and remove the ice basket (8).
• Wash the basket (8) and the ice scoop (10) with warm
water and neutral detergent.
• Remove the plug from the drain opening (9) on the bot-
tom side of the unit and drain the remaining water from
the tank. Clean the unit as described in the chapter
«Self-clean function».
• Wash the tank with clean water and wipe it with a dry
soft napkin.
Note: when cleaning, do not tilt the unit more than
45 degrees or turn it upside down, otherwise the cooling
system may not work properly.
• Install the drain opening (9) plug back to its place.
• Clean the unit body with a wet cloth and wipe it dry.
• Set the ice basket (8) to its place.
• Close the lid (2).
TROUBLES, THEIR CAUSE AND TROUBLESHOOTING
Malfunction Possible reason Troubleshooting
The unit connected to the mains
doesn’t work
There is no contact of the plug with the
socket
Ensure that the plug socket is in contact
with the plug
There is no voltage in the mains Check for voltage in the mains socket
Increased noise during
operation
Power supply voltage is too low Switch the unit off and check the power
supply
The fan is faulty Contact the service center
The compressor is faulty Contact the service center
Full basket indicator glows on
the control panel, but there is
no ice
Full basket sensor (6) is faulty Contact the service center
Full basket sensor (6) is dirty Clean the full basket sensor (6)
Low water level indicator glows
on the control panel, but the
water tank is full
Foreign particles block the water supply
channels
Contact the service center
The pump is faulty
In case of other malfunctions, please contact the service center at the contact addresses indicated in the warranty cer-
tificate and on the website www.rondell.ru.
The following situation is not malfunction:
•
When the ice maker is first started, the water pump pumps for
5 seconds and then stops for 5 seconds, and then the pump
works again for 5 seconds, and then stops again for 5 seconds,

Похожие устройства

Скачать