Brayer BR1117 Инструкция по эксплуатации онлайн [8/68] 811626

Brayer BR1117 Инструкция по эксплуатации онлайн [8/68] 811626
8
EN
the button (15) « » will appear, the indicators of
the buttons (16, 17, 18) «
, , » will light up, all
three button indicators (16, 17 and 18) will ash, and
the boiler heating element will not turn on;
- to continue the operation, set the steam supply
control handle (9) «
» to the «0» position, the
indicators (16, 17 and 18) will stop ashing, the
boiler heating element will be switched on to heat
water.
Place any suitable bowl under the tip (11) for water.
Carefully turn the steam supply knob (9) «
»
counterclockwise for a quarter of a turn to release
steam and ll the boiler with water, in approximately
8-10 seconds close the steam supply by turning the
steam supply knob (9) «
» to the «0» position
Switch the water supply on by pressing the button (17)
«
», the pump will switch on and hot water will be
poured into the cup, pour the water out of the cup.
Repeat this procedure several times, the boiler will be
clean after that.
To switch the espresso machine o󰀨, press the on/o󰀨
button (15) « », the buttons (15) illumination will go
out.
ATTENTION!
- Do not remove the lter holder (5) during espresso
machine operation.
- Do not remove the lter holder (5) immediately after
preparing co󰀨ee as there is redundant water and
steam pressure inside the lter (5), let the co󰀨ee
maker cool down completely.
To remove the lter holder (5) turn the handle (4) to
the left «
» and remove the lter holder (5) (pic. 1).
AUTO SWITCH OFF FUNCTION
If no actions were performed during 25 minutes
after switching on, the co󰀨ee maker will switch o󰀨
automatically.
HOW TO MAKE A GOOD ESPRESSO
Use ground co󰀨ee for espresso co󰀨ee makers.
Slightly tamp the ground co󰀨ee in the lter (6), for
this use the ground co󰀨ee tamper (20).
Co󰀨ee strength depends on the quality and grinding
degree of co󰀨ee beans. If co󰀨ee is pouring out too
long, this means the co󰀨ee powder is too ne or it is
tamped too strongly.
PREHEATING
To make a cup of hot espresso, it is recommended to
preliminary heat up the co󰀨ee lter (6) and the lter
holder (5).
Open the lid (13) and ll the tank (14) with water, or
remove the tank (14) and ll it with water, then install
the tank (14) back to its place.
Insert one of the co󰀨ee lters (6) into the holder (5).
Скачать